Program switch does not work

There were many vehicles made in 1957 when I was 4 years old :>D

Google

1957 (make model) wiring diagram

then look at the images tab.

And your instructions "Don't show me a wiring diagram" aren't going to work on this site. If you can't follow a wiring diagram, you need to use the services of an auto-electrician. I doubt anyone can remember working on a vehicle made in 1957.

I can can read a wiring diagram within limits, but no one knows what vehicle you have. There weren't even Haynes or Clymer service videos in those days, not even microfich. You could also try searching for specialist forums for the make and model. They are all a great resource and members will happily share knowledge and printed resources..

Does the fuse blow before or after you step on the brake? If it blows only after you step on the brake, and voltage from stop lamp switch only goes to rear brakes and not through multifunction switch. If only one connector at the rear for brake lamps, take connector loose, step on the brake, if the fuse still blows, the problem is before the connector. You could Use new wire from brake switch feed, when brake switch is activated, to the rear brakes. Leave pigtail at both ends, splice in new wire, You could let new wire just lay on the ground, for testing, from brake switch to rear brakes. If the brakes work and doesn't blow the fuse, Make the new wire permanent and route the wire properly. Just my opinion. I don't have wiring diagram for your model year.

What make , model , year and engine size ? That doesn't work on a lot of vehicles now a days ! Anti-theft systems , programming in the control modules . Plus on some the start circuit is a input to the PCM or the BCM , an hot wiring will not work .

ahh unless its a real top end car id bet not , no id be looking for a fuse that's bad instead

Maxima.org will have it.

volvo v70 Don't worry I'm sure you will get the solution of your problem, just check the link I attached
They have all wiring, schematic, and electrical diagrams, instant download.

For ford freestar key programming switch and its location.Click the link below and see the wiring diagram:----http://technoanswers.blogspot.in/2012/02/vehicle-wiring-diagram.html
---------This will help.Thanks.

You can try an internet search for the wiring diagram. No power to all the parking lights? Then probably the light switch. Make sure you have power to both sides of the fuse. If not the either wiring from the switch or the switch itself. Good luck.

No. not the switch. Check to see if you have power going into it. I don't have the wire diagram, but you can take a test light and check each line. At least one will light up with the key on. Certainly check your fuses.

Hope this helps

I hope this diagram works...I'm not great with MS Paint.