What is the torque spec for 2008 dodge 2500 6.7 deisel front wheel bearing
SOURCE: Changing front ball joints on Dodge 2500 2005
can it not be done without removing the hub ?? dont think you can get hub off without removing the track control ball joint?do you have the right tools??
SOURCE: what are the torque specs for main and rod bearing
go to autozone.com and set up a free account. You will then have access to vehicle repair guides and can get all the info and diagrams you need. Hope this helps!
SOURCE: How to replace front wheel bearing on a 2002 Dodge 1500
You take off the right tire. You have take all the bolts out from underneath the
SOURCE: Replaced rear axle pinion bearing and seal, need
There is no torque specs,this nut has to be tightened back like it was ,the best thing to do,was,to late now,is to use a torque wrench to remove the nut,and remember the torque,and when replacing it,torque it back to that spec,the reason being,there is a crush sleeve between the front pion bearing ,and the rear pinion bearing,and it has to be crushed to a certain amount,to aquire deepness into the ring gear,anyway just give it about 25 lbs torque,any more the crush sleeve will crush even more and the deepness of the pinion will be too much.
Tighten the spindle nut to 149 ft-lbs to seat the bearing then
. rotate the axle 5 to 10 times to seat the hub bearing, then
tighten the spindle nut to a final torque of 263 ft-lbs I would just use a good impact gun to get it there.
567 views
Usually answered in minutes!
×