Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on May 16, 2014

Where is my upstream oxygen sensor on my 2008 Suzuki sx4?

5 Related Answers

Molson02536

Harvey N Tawatao

  • 3854 Answers
  • Posted on Apr 13, 2009

SOURCE: I'm trying to locate the spark plugs in my suzuki 2008 sx4.

You remove the rectangular plastic cover on top of the engine(2 screws), under that is the plug wires and spark plugs. Pull wires straight up, remove plugs with proper spark plug socket, extension and ratchet, reverse to install.

Platinum plugs are not required but will allow longer change intervals. Check the gap but do not gap them, if they are not properly gapped. Bring them back and asked for new ones.

The metal's on the Platium plugs are harder then copper plugs and can break upon trying or break in your cylinder when in uses.

Good luck and hope this helps

Ad

Anonymous

  • 4669 Answers
  • Posted on Apr 10, 2010

SOURCE: How often should i change my oil in a suzuki sx4

every 3000 miles or 3 months. You should change it before the light comes on. Unless you are using synthetic oil.

Anonymous

  • 2 Answers
  • Posted on Jun 26, 2010

SOURCE: 2007 suzuki sx4 emission control light on. 17000 miles

My light in my 2007 SX4 just came on. Apparently my oxygen sensor is wrecked... allegedly from oil dropping on it during oil changes. Did the light come on after the most recent oil change?

allobd2

  • 1207 Answers
  • Posted on Oct 23, 2012

SOURCE: where is the knock sensor located on my 08 suzuki sx4

The P0327 means Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor).
the knock sensor is located in the front of the engine located behind the oil dip stick just to the left.
_______________
Ktag K-TAG

Anonymous

  • 6 Answers
  • Posted on Feb 12, 2013

SOURCE: keyless remote not working on my suzuki sx4

think it may be a new battery in key fob had same prob with mine and used other spare key and works fine now ..

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Why did I fail emission test on 2009 Suzuki Sport SX4 because of Oxygen sensor?

O2 sensor allows ECM to fine tune fuel/air mixture going into the engine.
No O2 sensor will put ECM into "closed loop" mode and use a lot more fuel.
0helpful
2answers

2009 suzuki sx4 window fuse

On this website you find fuse box diagram and description for Suzuki SX4

Maruti Suzuki SX4 Petrol fuse box diagram Auto Genius
0helpful
1answer

Light engine on the 2008 suzuki sx4. replaced the front 02 sensor and plugs. still light stays on and says 02 senor could be the problem.

There are several O2 sensors. There 's the sometimes from 2 to 4 on each vehicle. They are located at the pipes before they get to the catalytic converter and after. It may be that the one you replaced is good but one or all of the others are not good.
5helpful
1answer

Where is the knock sensor located on my 08 suzuki sx4

The P0327 means Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor).
the knock sensor is located in the front of the engine located behind the oil dip stick just to the left.
_______________
Ktag K-TAG
1helpful
1answer

Where is the suzuki sx4 heater sensor located? i have a "HO2S Heater Control Circuit Low (Bank 1 Sensor 2)" problem and do not no where to find that sensor or how to fix that problem

That is an error for a heater oxygen sensor (H02S). It's located on the exhaust pipe after the catalytic converter. If you have a 4 cylinder, there will only be one catalytic converter so it will be pretty easy to figure out which sensor to replace. If you have a 6 cylinder you will have to determine which bank is Bank 1 and which is Bank 2. If you can find a cylinder identifiction diagram bank one will be the side that cylinder # 1 is on. Whenever i have encountered a similar code it has always been a bad oxygen sensor. So, inspect the wiring to the sensor and if all checks out, replace the sensor.
2helpful
3answers

2007 suzuki sx4 emission control light on. 17000 miles

maybe the sensor is faulty, only having 17k miles on it i'm guessing that is what it is, get it looked at or changed
7helpful
2answers

2007 Suzuki sx4 engine light on after oil changed, How to turn it off?

The solution is that when the oil filter is removed, oil gets on the O2 sensor and ruins it. Must cover the O2 and that keeps the oil off. To keep the check engine light off, is to replaced the O2 sensor. Problem solve. Later on sx4's they move the O2 in a different spot. I work on Suzuki cars. Don
Not finding what you are looking for?

525 views

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...