How do you replace spark plugs on a 2006 ford five hundred

SOURCE: 2006 Ford Five Hundred -- Where's the fuel filter?

right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.

SOURCE: Driver side rear turnsignal bulb needs to be

This is straight from the owner's manual.

#1 Make sure the headlamp switch is in the OFF position and open the trunk.
#2 Carefully pull the carpet away to expose the backside of the tail lamp assembly.
#3 Remove the nut and washer assemblies, then pull the lamp assembly away from the vehicle.
#4 Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly.
#5 Pull the bulb straight from the socket.

Install new bulb(s) in reverse order.
Good luck

SOURCE: codes p2106

I think you'll find it's a problem with your throttle you might need to talk to you local ford dealer but don't get talked into getting bit's replaced! I've been tld that you can put a recommended cleaner into your fuel tank and this can sometimes cure the problem - worth a go................

Greg Bernett

• 2993 Answers
• Posted on Jan 17, 2011

SOURCE: Where is the fuel pump

Yep!



Removal & Installation

1. Disconnect the negative battery cable.
   
2. Drain the fuel tank.
   
3. Remove the rear lower seat cushion.
   
4. Remove the fuel pump module cover.
   
5. Remove any dirt that has accumulated around the fuel pump module attaching flange to prevent it from entering the tank during service.
   
6. Disconnect the fuel pump electrical connectors.
   
7. Disconnect the fuel pump quick connect coupling from the fuel pump module.
   
8. Disconnect the fuel vapor tube quick connect coupling from the fuel pump module.
   
9. Turn the fuel pump module locking ring using a locking ring removal tool, and remove the locking ring.
   
10. Remove the fuel pump module and disconnect the quick connect fittings from the bottom of the fuel pump.
    

SOURCE: how to remove headlamp assembly

bulb replacement?

You may be able to clear bumper cover by pusihing down while pulling out lamp.

Please rate.
---------------------------

SECTION 417-01: Exterior Lighting 2005 Freestyle/Five Hundred/Montego Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 03/14/2005
Headlamp Assembly - Five Hundred, Montego Printable View (211 KB)
Item Part Number Description 1 W702706 Top headlamp assembly bolts (2 required) 2 W704551 Side headlamp assembly bolt 3 W702706 Front headlamp assembly bolt 4 13005/13006 Headlamp assembly (RH/LH)
Removal

1. Remove the front bumper cover. For additional information, refer to Section 501-19.

1. Remove the 4 bolts and the headlamp assembly.
   • Disconnect the electrical connectors.

1. Connect the electrical connectors and position the headlamp assembly in place.

1. Install the side headlamp assembly bolt.
   • Tighten to 11 Nm (8 lb-ft).

1. Install the front headlamp assembly bolt.

1. Install the top outboard headlamp assembly bolt.

1. Install the top inboard headlamp assembly bolt.

1. Install the front bumper cover. For additional information, refer to Section 501-19.