Question about 1994 Jeep Cherokee Country
Posted by Anonymous on
9 hrs on a 4wd 7 on a 2wd. That is chilton/mitchell time. a good tech will beat that time but deserves to be paid accordingly
Posted on Jun 05, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Rear Axle Seal Replacement
remove rear tires, then remove brake calipers and rotors, then remove the 4 nuts (each side) that hold the axle shafts to the axle tube (located around the axle tube behind the backing plate) then using a slide hammer pull the axle shafts out, next using a die grinder and an air hammer get he retainer collar and the bearing off (without damaging the axle shaft) then remove the seal and the outer race which will still be in the housing. next put it all back together, make sure the plate with the studs is still on then slide the seal, bearing, then retainer on (all new parts) and using a press push them all the way back on. then is simple reassembly.
Posted on Apr 22, 2009
You will need to remove the differential rear cover,drain fluid, remove wheel, brake drum, (rotor) . Unbolt center diff. pin, carefully remove (don't loose shims) push axle in remove lock keeper, then slide out axle, replace seal, put some grease on it, slide axle in reverse all to install.
Posted on May 22, 2009
just go the above link i think u can get one online for free please rate my answer
Posted on Jul 03, 2009
SOURCE: rear main seal replacement for
Wrong. just remove the oil pan, exhaust downpipe and O2 sensor, and starter. take off the crank bearing brace and finally remove the rear main bearing cap. half the seal will be in the cap and half you push out from around the crank with a small brass punch so as not to damage the crank pull out with needle nose pliers and slide the new one in ( noting that oil should go on the mating surface of the crank and liquid dish soap on the outside of the upper seal). rtv the lower seals wings (top and bottom) and reinstall. rear main cap 80ft.lbs i believe, 35ft.lbs for the bearing brace. or just follow this tutorial with pics http://dailydriventj.com/forum/viewtopic.php?t=811
Posted on Jul 14, 2009
6.5" in all the doors dash is wierd. 2.75" but i have been able to squeez in a 3.5"
Posted on Feb 04, 2010
Testimonial: "thank you so much, that helps me out as lot"
Tips for a great answer:
Sep 19, 2015 | Jeep Cars & Trucks
Oct 09, 2011 | 1994 Jeep Grand Cherokee
Apr 22, 2011 | 1994 Jeep Grand Cherokee
Sep 08, 2010 | 1994 Jeep Grand Cherokee
Aug 19, 2010 | Jeep Grand Cherokee Cars & Trucks
Jul 16, 2010 | 1994 Jeep Grand Cherokee
Dec 28, 2009 | 1994 Jeep Grand Cherokee
Feb 20, 2009 | 1994 Jeep Cherokee
Dec 05, 2008 | 1994 Jeep Cherokee
May 27, 2008 | 1994 Jeep Cherokee
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: