Timing belt settings
SOURCE: 1991 mazda b2200- timing belt changed
The keyway and or the dot on the crank should be line at 12 oclock. You will see a point on the oil pump housing to go by. On the camshaft the pointer will be at 12 oclock also. Use the O on the camshaft to the top at mark. Be sure to look at the dist. roter to make sure that it is pointing at the #1 spark plug wire. I could get 180 out of time. If you do it right it should start up right away. then you can use a timing light to finish it.
Good Luck [email protected]
SOURCE: mazda astina water pump
remove rocker cover, harmonic balancer and belts, remove timing cover and you will find the water pump on the left side of the timing belt set up good luck mate it is a little tite in there
SOURCE: 1989 mazda astina 323 5 spd manual clutch fluid??
open your bonnet check to see @ gearbox if the-res is cable, or a cylinder, the cable is Usualy visible on the top of the gearbox if theres a cable theres no clutch flu-ed needed. Note that your gearbox uses oil. Usualy on older models like 1989 the use a clutch cable no flu-ed needed
SOURCE: timing settings
you should have timing marks that are lined up on your engine. You have your crank to line up at a certain point as well as the two cams. I don't know off the top of my head where these might be for this car but you can find it in a Haynes or Chilton manual if you so desire to also learn more about your overall car and take care of this or i can find these specs and send them your way. Up to you?
SOURCE: mazda astina pop up lights wont go back down
Try to check if there is something stuck to the motor of the pop-up lights mechanism. You can see it below the fenders. The fender liner should be removed.
253 views
Usually answered in minutes!
×