1996 Chevrolet C1500 Logo

Related Topics:

A
Anonymous Posted on Jun 04, 2014

How to remove horn button on 1996 chevy truck

Want to change steering wheel on 1996 chevrolet c1500

5 Related Answers

Anonymous

  • 1010 Answers
  • Posted on May 15, 2008

SOURCE: horn cover

it takes a special puller to remove the steering wheel. the air bag just pops out with a release tool in the release hole on the side of the steering wheel

Ad

Anonymous

  • 61 Answers
  • Posted on Jan 29, 2009

SOURCE: chevy steering wheel controls

You first have to disarm and remove the air bag (unscrews with bolts from behind the steering wheel) and then you will see the screws for the switches. Only the silverado awitches will work.

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Mar 19, 2009

SOURCE: how to remove carrier bearing

U must remove the axles, to do this pull the diff cover off, then remove the pin that retains the large center pin that is between the spider gears, pull the axles out far enough to clear diff carrier, remove left and right carrier bearing caps, mark the adjustment sims and caps (very important) as to which side they came from, u will most likely need to have a press to remove and install the new carrier bearings, they are pressed on, when u reinstall put the shims back in with a brass hammer or large brass drift punch, they are cast iron and break very easily, make sure to use the proper gear lube, do not overfill, also replace the axle seals and check the axle bearings for wear, I will bet they are worn out as well, the rule really is that if one bearing goes south then the metal from that will ruin the rest of the bearings, in the shop we recommend all differential bearings be done, if not we can't guarantee the job.

Anonymous

  • 232 Answers
  • Posted on Jun 02, 2009

SOURCE: 2003 cavalier horn problem

It's a pretty long procedure to type out,so go to autozone.com,register and input your vehicle info,then you can access their online repair guide,they have the procedure to disarm the air bag(s),they are under the chassis electrical heading,follow them to a tee so you don't set the air bag off,the cover maybe screwed on thru the back of the steering wheel or may just be held in place with tension clips,the repair guide isn't clear on this so look for srews first,if you don't see any you should be able to pry gently off with a screwdriver,the horn switch will be in the cavity underneath or possibly attached to the back of the air bag itself,it's just a small springed tab with a wire attached that touches the metal of the steering column.I hope this info helps and please be careful to follow the instructions.

Anonymous

  • 1450 Answers
  • Posted on Apr 12, 2010

SOURCE: 1986 chevy c10 truck. pulled steering wheel to

THE horn piece should turn with the wheel lock plate. if it does not then something is not installed properly

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Replace horn button in steering wheel

change the settings of wiring and get button and connect horn wire to it
0helpful
1answer

How do I change the ignition cylinder on a 97 Chevy c1500 if can't turn key to on/run.

You need to remove the steering wheel , turn signal control and in the steering column you will find a pin that holds the tumblers in place for the key switch. You can remove the pin and then remove the key tumbler and replace it. Go to You Tube and they have videos on just what you need to do to remove the steering wheel and etc. Hope this helps.
0helpful
2answers

How to disconnect the horn to a 1989 chevy truck 2500 4x4

Well you can find the horn on the front by the grill or on the wheel well. I prefer the easy way. Pull the fuse for the horn.
Hope this helps. God Bless :O)
3helpful
2answers

How do you take the steering wheel off of a 1986 chevrolet c10

1. Turn the steering wheel from side to side until it locks into place. This will make the process a bit easier, as the wheel won't be turning as you work.

  • 2 Remove the horn button in the center of the steering wheel by pulling it off towards you. This will expose the steering wheel nut at the center.

  • 3 Unbolt the center bolt from the steering wheel, using the 1/2-inch ratchet, extension and socket. This might free the steering wheel right away, but most likely you'll have to proceed to the next step.

  • 4 Position the steering wheel puller on the steering wheel such that the center bolt on the puller is on the center shaft of the wheel. Then thread in the bolts supplied with the puller into the two threaded holes on either side of the center shaft on the wheel.

  • 5 Tighten down the center bolt on the steering wheel puller using the 1/2-inch ratchet and socket until the steering wheel pops free. Then remove the steering wheel puller from the steering wheel.
  • 0helpful
    2answers

    To how remove key ignition 1996 chev

    You have to remove your steering wheel and the with the assistance of a special tool you remove the plate under the steering wheel. Then you remove the screw that holds the ignition switch it will come out.
    1helpful
    3answers

    Where is the horn relay located on a chevy wt1500

    Front seating area, driver side, behind dash, driver side of steering column, mounted in relay block
    0helpful
    2answers

    Horn is not woorking on 2008 chevy 2008

    first test for power at the horn using a test light if no power then its not the horn check the fuse if fuse is good your problem can only be the clock spring which is located underneath the steering wheel,remove the wheel and its right there replace it and you will have horn power again.
    2helpful
    2answers

    How to fix a 1984 Chevrolet Pickup Horn.

    First locate it. Then check for power. Some horns use the mounting bolt as a ground. Check this. A good ground is critical. Now if you have power and a good ground check the switch in the steering wheel. Last option is you may need a new horn. Try any auto parts store.
    0helpful
    1answer

    Steering wheel ring

    Remove horn cover, just pops off or slides off. Disconnect wire and set cover aside. Oh, point the wheel straight up and down. Find the right socket and remove that big nut right there once that nut is off you can use a steering wheel puller and remove it, OR what I do, is just start pulling on the wheel. Pull on top then bottom, side to side, it takes a little muscle to do so. It will pop off. Once off, put new wheel on making sure it's straight up and down, and put the nut back on the horn cover. Boom, your done.
    2helpful
    2answers

    Horn cover

    it takes a special puller to remove the steering wheel. the air bag just pops out with a release tool in the release hole on the side of the steering wheel
    Not finding what you are looking for?

    598 views

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    ZJ Limited
    ZJ Limited

    Level 3 Expert

    17989 Answers

    john h

    Level 3 Expert

    29494 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    15088 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...