SOURCE: Isuzu bighorn diesel 4jg2 engine timing diagram
http://www.jeepolog.com/UserFiles/downloads/trooper_manual.pdf
This site has it .
SOURCE: how do i reset my timing beltwarning light after
this is not right there should be a rubber grommet in cluster lens take out and press button with ignition on to reset light just like resetting trip meter
SOURCE: Isuzu bighorn 1994 manual, slips out of 4th and
check gearbox oil level as dry syncro rings can also cause your box to jump out of gear ,detent springs are only for giving u the feel of positive gear engagement.
SOURCE: hi ive got a 1996 isuzu bighorn ive attempted to
Timing belt installation
1. Ensure locking bolts located correctly [4] & [5] in the picture below:
CS = Crankshaft
CA = Camshaft
IP = Injection Pump
2. Ensure timing marks aligned [10].
3. Fit timing belt in clockwise direction, starting at crankshaft sprocket.
NOTE: "ISUZU" lettering on belt should be readable from front of engine.
4. Slacken tensioner pulley bolt [9]. Push tensioner pulley against belt.
5. Ensure belt is taut between injection pump sprocket and tensioner pulley as well as crankshaft sprocket and camshaft sprocket.
6. Position tensioner lever [8] against tensioner pulley housing.
7. Remove locking bolts from sprockets [4] & [5].
8. Apply a load of 10 ... 12 kg to tensioner lever. Use spring balance [11].
9. Tighten tensioner pulley bolt to 80 Nm.
10. Turn crankshaft slowly 45 degrees anti-clockwise. Use spring balance to tension belt.
11. Repeat tensioning procedure at 45 degrees intervals for one anti-clockwise turn of the crankshaft.
NOTE: DO NOT turn crankshaft clockwise during tensioning procedure!
12. Fit tensioner lever to original position. Tighten nuts [12].
13. Install: Injection Pump flange [6], Camshaft sprocket flange [7], and water pump pulley.
14. Install components in reverse order of removal & refill coolant.
PLEASE DO RATE MY RESPONSE. THANKS!
805 views
Usually answered in minutes!
×