How to remove the dash of a 1991 corvette - 1991 Chevrolet Corvette

remove transmistiom,torkconverter and fly wheel.this will give you access to the seal.

Cant help but had to post you are lucky to have such a cool car...lol good luck....

you have to remove the dash and in most cases the seats are even removed to help with the extra room. One corvette forum that i really love is www.smokinvette.com . Lots of useful info there.

Good luck

Check this info...



Hope helps (remember rated thsi).

RECHECK THE WIRING TO SPEAKERS AND CHECK THE STERO IS COMPATIBLE TO WIRING.

Hi, check to see if you have any surpressor fitted to the alternator?

replace blower control module

If the 1991 is anything like th 1969 to 1982, the ground is open under the dash at the wiper switch. Check for the ground at the wiper motor when the wipers decide not to work. Grounding is problematic on a fiberglass bodied vehicle. Hope this is of help.

u may need a speedometer signal generator if dash gage is on just not reading speed its located on the left rearend of tranny just remove wiring clip and 1 hold down bolt and pull out easy to replace but if its problem with dash gauge's u may need a dash printed circuit board for speedo/tach

well your in luck i just removed mine today lol. there are 5 1/4 inch screws on the bottom side of the dash on the passenger side of the car remove them pull the plastic cover down and disconnect the light mounted on the piecce you just removed next make sure your battery is disconnected cause it may fry it if power is connected. Next you will need a 10mm look straight up you will see the box it is aluminum with 2 wire harness attached. There is a metal clip holding it attached pull it back and un hook the harness then it will slide right out.