Question about 2003 Toyota RAV4

1 Answer

How to replace the headlamp of 2003 rav4? - 2003 Toyota RAV4

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Toyota Master
  • 846 Answers

Please go to this site on pc. this will tell you how to change headlights. .ehow.com/how_6232786_change-headlight-bulbs-toyota-rav4.html

Posted on Jun 14, 2014

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove an old headlamp on a 2003 rav4?


The lamp, or the entire housing?

The lamp is tight, but not hard. It is under the rubber cap on the back of the housing. It's tight with other items, but it can be done without removing anything. Unplug the lamp, remove the rubber cap, release the wire bail, and remove the lamp.

The housing is a major pain. You need to remove the grille and the trim strip that runs under the headlights and grille. It is retained by a couple of hidden plastic clips at each end, you need a pair of small screwdrivers to depress the locking pins to release them. Wrap the screwdrivers so you don't mar the paint.

Once that is out of the way, work around the housing and remove any bolts attaching it, then work the housing out of the fender.

Jun 14, 2014 | 2003 Toyota RAV4

1 Answer

2003 Toyota Rav4 has P0303, P0300, P0301 and P0174 check engine codes. I replaced spark plugs. Still running rough


Sounds like you may have a weak fuel pump.Check your fuel pressure and if its not within the specs that are required then replace the fuel pump and filter.

Aug 17, 2012 | 2003 Toyota RAV4

1 Answer

I need a diagram for the serpentine belt on a 2003 Rav4


Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------This will help. Thanks.

Feb 02, 2012 | 2003 Toyota RAV4

1 Answer

How to replace driver side headlight 2003 nissan altima


To Remove:
  1. Ensure that the lighting switch is in the OFF position.
  2. Disconnect negative battery cable.
  3. Remove or disconnect the following:
  • Front Fascia
  • Headlamp mounting bolts.
  • Headlamp by sliding it foward.
  • Headlamp connectors.


tecnovative_52.gif
To Install:
  1. Install or connect the following.
  • Headlamp connectors.
  • Headlamp and mounting bolts.
  • Front fascia.
  • Negative battery cable.

Jan 14, 2011 | 2003 Nissan Altima

1 Answer

My friends 2009 Rav4 low beams are so dim, I didn't think that she had her lights on, but she did. What could be the problem?


You could have bulbs that are starting to go bad or a bad ground. The bad ground is the most likely cause since it happened to both at the same time, but it should effect the high beams also. So the first thing to check would be check the grounds at both headlamps and check the voltage supply at both headlamps. It is possible that you have low voltage and that would have to be checked at the switch and the dimmer if that is the case.

Mar 18, 2010 | 2009 Toyota RAV4

1 Answer

Parking light burnt out


You should be able to get to it by removing the headlight

  1. Remove the headlamp fasteners.
  2. Using a pry bar, gently pry in the center area of the headlamp assembly. Pry the headlamp assembly straight forward in order to unsnap the headlamp ball stud from the ball stud socket.
  3. Slide the headlamp straight forward and disconnect the headlamp electrical connectors from the forward lamp wiring harness.
  4. Remove the headlamp from the vehicle.

May 04, 2009 | 2003 Buick LeSabre

1 Answer

Passenger headlight don't work 2003 lincoln navagator


high beam or low beam? or both of them on one side.

  • One low beam headlamp is inoperative
  • Central junction box (CJB) fuse 23 (10A) (RH headlamp).
  • CJB fuse 25 (10A) (LH headlamp).
  • Circuitry.
  • CJB.
  • Go To Pinpoint Test C .


  • One high beam headlamp is inoperative
  • Circuitry.
  • Headlamp assembly.
  • Go To Pinpoint Test D .

  • The high and low beam headlamp is inoperative on one side
  • Circuitry.
  • REPAIR ground circuit 57 (BK).


  • Headlamp switch
  • Multifunction switch
  • Vehicle Security Module
  • Central junction box (CJB) fuse(s):
    • 17 (15A)
    • 23 (10A)
    • 25 (10A)
    • 35 (20A)
    • 40 (20A)
  • Circuitry
  • Headlamp bulbs
  • Daytime running lamp (DRL) relay



Apr 19, 2009 | 2003 Lincoln Navigator

2 Answers

Diagram 2003 toyota rav4 serpitine belt routing


http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?partName=Engine+Mechanical&pageId=0900c1528019c35b&partId=0900c1528019c35b

go here i think this will help

Apr 09, 2009 | 2003 Toyota RAV4

Not finding what you are looking for?
2003 Toyota RAV4 Logo

Related Topics:

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...