SOURCE: 2003 Ford Ranger/2.3 O2 sensor - How many and Where located ???
Engine Heated oxygen and catalyst monitor sensors—2.3L engine
SOURCE: ATS sensor on 2003 Ford Ranger/2.3 engine
In the bottom of the air box.
Please rate this solution.
SOURCE: P0340 Code Camshaft Position Sensor
The Camshaft Position (CMP) Sensor detects the position of the camshaft in order to identifiy when piston No. 1 is on its compression stroke. The CMP sensor is used for ignition timing in the Ford DIS igntion system, but not in the EDIS igntion system. Both DIS/EDIS use the CMP signal for synchronizing the firing of sequential fuel injectors.
On the 3.0L vulcan engine, the CMP signal is generated by a single Hall-Effect magnetic switch, activated by a single "vane" spinning around by virture of a synchronized shaft which is driven by the camshaft.
The CMP sensor & synchronizer/shaft are located behind the intake manifold (i.e., back near the firewall on a Ranger) on the top of the cylinder block. If you just need to replace the sensor, it is a simple job of unplugging the electrical connector and removing the screws holding the sensor in place. Here is a sketch of the sensor to give you an idea what to look for:
SOURCE: how do i time camshaft position sensor in 1996
most part stores have the tool just tell them you need the cam sync tool for your 3.0 v6 ranger. this tool attaches to top of cam sync, put the motor at tdc by pulling the #1 out and turning it till you on comp stroke and look at crank mark then drop in new sync with tool on it set it bolt down the take tool off install sensor and plug in. if you get it wrong and the check eng light is on just redo but with the tool it is easy . and then there is the i have no choice way you take then sensor off the cam sync then make your marks take a pic of the thing and reinstall new one to the same mark dont worry about tdc or anything this way you just pull out and put in same way just make sure its in same place take a dig pic and mark it real good
SOURCE: Where is the Engine Temperature
On 2.3l ford ranger the Engine Coolant Temperature Sensor is located on the top RH front of the engine, in the water outlet tube.
----------
this will help.Thanks.Helpmech.
212 views
Usually answered in minutes!
×