Is there a fuse for the back window in a 91 Toyota 4 runner
SOURCE: replace front brake pad 2003 toyota 4 runner
Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers
SOURCE: 1986 Toyota 4 Runner - Tailgate window wont go down (electric)
hi phil, dont know if it will be of help but we had this problem ,try making sure rear wiper blade is in the proper resting place,i know it sounds to simple but it was our solution in the end after a machanic spent hours and hours on our 94 surf plus££££s, hope this is your answer, good luck. regards Reg
SOURCE: Wiring for Toyota 4 Runner Alternator Fuse
it should be in the underhood fusebox on the right.
SOURCE: Toyota 4runner gate window, wiper, and keyless entry not working
make sure the back window is all the way up then try the wiper, if it still does not work then it is a sensor for the rear window (about $30.00) if you installed it yourself
I’m happy to help further over the phone at https://www.6ya.com/expert/john_5260ce46f2f674cc
SOURCE: rear window and passenger windows will not
The last couple of times I have seen this complaint, the "Lock" button on the master (driver's door) switch had been depressed. Unlatching the lock button (pushing it again) solved the problem. On most cars, when the lock button is depressed, the windows can still be operated by the driver, but prevent the windows from being operated by the passengers. Toyota is different. If the lock button is depressed, nobody, including the driver can work the wndows.
81 views
Usually answered in minutes!
×