Where is the fuse for turn signals on 2002 jeep grand Cherokee

SOURCE: 2002 jeep cherokee laredo

the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.

Marvin

• 85242 Answers
• Posted on Mar 02, 2009

SOURCE: Turn signals not working on 2001 Jeep Grand Cherokee

replace the turns signals flasher unit.

SOURCE: 2002 wj jeep grand cherokee p1756

The governor pressure sensor is the most likley cause however an inspection of fluid or debris in trans pan would be a good idea to make sure there's nothing excessive in it. Attached is a list of possible causes however the senor would be the most common.

POSSIBLE CAUSES

• Powertrain control module
• 5 volt supply circuit open
• Check transmission fluid level and condition
• GOV press sensor signal circuit shorted to voltage
• GOV press sensor signal circuit shorted to sensor ground
• GOV press sensor signal circuit shorted to ground
• GOV pressure sensor signal circuit open
• Sensor ground circuit open
• GOV press sensor signal circuit shorted to voltage inside transmission
• 5 volt supply circuit open inside transmission
• Intermittent governor pressure solenoid
• Internal transmission problem
• Oil burnt or oil pan has excessive debris
• Other transmission DTC'S
• GOV press sensor signal circuit shorted to sensor ground inside transmission
• Valve body
• GOV press sensor signal circuit shorted to ground inside transmission
• GOV press sensor signal circuit open inside transmission
• GOV press sensor ground circuit open inside transmission
• Governor pressure sensor (high)

SOURCE: How do you program a 2002 Jeep Grand Cherokee FOB?

if you have an original working fob and your owner's manual,it will explain procedure,otherwise will have to go to dealer to be programmed

SOURCE: overhead console completely dead 2002 jeep grand cherokee laradeo

Check the fuses for the overhead console, could be that if not then the console needs to be replaced.....