How to remove left front outside door handle
SOURCE: cannot remove outside door handle
If you look under the handle you will see two round flat rivet heads. You will need to remove the door skin. Roll the window all the way down. Pull the plastic trim up off the window regulator arm/handle and unscrew it, there is a screw inside the arm rest in the place where your fingers go, and another screw behind the inside door handle that holds the plastic molding in place. After those are unscrewed it is just a matter of popping off the skin with a suitable pry bar or trim plug pry bar tool (the door skin is attached by plastic barbed plugs that go around the outside of the door) Pry from the bottom 1st, then the sides. Lift skin away from door from bottom and then pull up to remove skin from door...this will release it from the top where the skin attaches inside the door next to the glass.
Temporarily attach the window handle and roll up the window. Cut the doors inside plastic liner to gain access to the inside (Duct Tape this all back up air tight when re-assembly). Keep that window handle close...you may have to adjust the window height to move the glass/arm out of your way.
Once the outside handle is drilled out (use a big drill bit and go just deep enough to break the head off then use a punch to drive out the rivet) you just have to unhook the metal arm that goes to the latch. Bolt on a new handle and re-assembly is reverse of disassembly. Take advantage of having the inside of the door open to lube up the window regulator or even spray a good dose of Rust Check etc inside to protect it from rust. Rangers are pretty bad for having the bottoms of the doors rust out.
SOURCE: Rear door will not open on my 2007 Ford Fusion.
use the fob and keep clicking unlock/lock button see if everything is moving.then try banging outside of the door about 6 inches from door handle while pressing unlock.has worked on some other cars like vw audi and vauxhall
SOURCE: 2006 Ford Fusion. Left front door inside handle
This link is from the handle to the latch. The door panel has to be removed in order for this problem to be fixed. The linkage is inside the door panel, it is a small diamater metal rod called a link. If you do the job yourself be careful not to break the door panel. In a shop, the labor is 1 hour for the job & if any, parts will be a seperate charge.
SOURCE: left front door jammed...handle on the inside
You will need to pull door apart, to find out where ROD fell off linkage assembly. From there its pretty easy.
Either the linkage connected to the handle has come off, or the piece on the handle inside has broken. You will need to remove the panel from the door and repair or replace the handle.
278 views
Usually answered in minutes!
×