SOURCE: 94 Jeep Wrangler intermittently stalls when put in reverse, drive
Take the air inlet hose off where it enters the throttle body and take a look at the throttle plates. It is likely that they’re dirty and have a build-up of carbon deposits. That is the most common cause for stalling that we see in the shop for your vehicle. Sometimes all it takes is a good cleaning to cure the stalling problem. There is an idle speed setting on your Jeep, but to check and/or perform this service step requires the use of a computer scan tool for your vehicle. If the cleaning doesn’t help ask a repair facility to check and reset, if needed, the minimum idle speed on your Jeep.
Thnx.
SOURCE: 96 Jeep Grand Cherokee wont go into reverse
chheck your tranny fluid. if it's ok, probably need tranny work done.
SOURCE: My jeep rattle's/vibrates and it sounds like a truck when you let of the gas.
check motor mounts defective ones can cause engine to vibrate
SOURCE: Transmission Troubleshooting 1992 Jeep Cherokee
Check the trans fluid level first. To do this have the car running at operating temp check the level if low adjust to proper level and recheck. If thats not it I will help u trouble shoot it further. Sounds like a bad torque converter.
SOURCE: vibration when using reverse gear
Have your motor mounts checked very soon. This only shows in reverse because reverse causes a backward torque than the engine does in forward gear.
101 views
Usually answered in minutes!
×