Where is the tail light fuse located

Question edited for clarity.
Question moved to model category.

tail lights don't need relays as the amperage is very low. Only headlights and fog lights use relays.

https://www.google.com/search?q=1993+Nissan+Pathfinder.+Where+is+the+tail+light+relay

Fuse Box diagram

https://www.google.com/search?q=1993+nissan+pathfinder+fuse+box+diagram

..

Look at factory wiring diagrams an test electrical circuit.

Factory Service Manuals - NICOclub

System Description EKS008NW Control of the parking, license plate, and tail lamp operation is dependent upon the position of the lighting switch (combination switch). When the lighting switch is placed in the 1ST position, the BCM (body control module) receives input signal requesting the parking, license plate, and tail lamps to illuminate. This input signal is communicated to the IPDM E/R (intelligent power distribution module engine room) across the CAN communication lines. The CPU (central processing unit) of the IPDM E/R controls the tail lamp relay coil. When energized, this relay directs power to the parking, license plate, and tail lamps, which then illuminate. Power is supplied at all times ? through 10A fuse (No. 41, located in the IPDM E/R) ? to tail lamp relay, located in the IPDM E/R, and ? through 50A fusible link (letter f , located in the fuse and fusible link box) ? to BCM terminal 70. With the ignition switch in the ON or START position, power is supplied ? through 10A fuse [No. 1, located in the fuse block (J/B)] ? to BCM terminal 38. With the ignition switch in the ACC or ON position, power is supplied ? through 10A fuse [No. 6, located in the fuse block (J/B)] ? to BCM terminal 11. Ground is supplied ? to BCM terminal 67 ? through grounds F14, M57 and M61.

I had an S-10 pickup that had a tail light out. It had two fuse panels one inside the cab and the main one under the hood. They had a fuse for each tail light and it was in the main fuse box under the hood. You'll need a way to check your fuses if you can't see witch one is bad. They were very small fuses in my S-10. Hope this helps

The fuse box to a 2003 Chevy Silverado is located under the hood

The tail lights in your 2011 Honda Odessey are computer-controlled. The fuse that protects the tail lamp circuits is FUSE Number 22, located in the underhood fuse and relay box located in the right rear of the engine compartment. It is a 10 Amp fuse. There is also a tail light relay located in the same box.

Please NOTE: If the fuse is blown, the cause of the fuse blowing MUST be located and repaired. Simply replacing the fuse will only result in another blown fuse.

Also, relay failures are pretty rare. If you can find another relay in the relay box with the same part number on it, you can swap them to see if this helps.
If this does not get your tail lights working, you will have to scan your computer network for possible fault codes in order to locate the cause of the problem (which is really a good idea to BEGIN with).

you have a blown fuse for the running lights,consult your owners manual for a fuse location for tail light fuse location.then replace the fuse.your tail lights should be off when replacing the fuse.after you replace the fuse,turn the lights on to see if this repairs your problem.thank you for choosing fixya.com

TAIL LIGHT FUSE WILL BE WITH LICENSE PLATE LIGHTS FUSE CHECK UNDER HOOD IN FUSE AND RELAY BOX FOR A 10 AMP FUSE.THE FUSE COVER WILL HAVE FUSE LOCATION.

You should have a fuse panel under you dash inside. This is where the fuses are located for lights. Don't know the exact location, but you can pull each fuse to see if it is bad. This won't hurt anything. It just keeps you from hunting down a diagram of where the fuse is located.

The tail light fuse has to be located in one of the fuse boxes. IF it is not on the one located in the interior of the vehicle that is another fuse box located under the hood, normally near the air cleaner.

The fuse is no.8 (15amp) in the interior fuse panel however it works all the park lights front and rear.