SOURCE: Where is the knock sensor 2 (bank 2) located on a
I don't have a diagram but they are under your intake manifold. It's not to bad of a job. You don't have to remove the fuel rails or the injectors, they can come up with the intake. The #2 knock sensor is the one in the rear. I will suggest getting both of them and also the harness and do it all while you have it apart. I believe you will find that water has gotten down in the hole where the knock sensors are located. Make sure to clean it out very good with compressed air before you install your new knock sensors.
SOURCE: Where is the location of the knock sensor for a 2005 HD 2500 6.0
HAS TWO KNOCK SENSORS they are both under intake in valley of engine. remove intake and will see two black grommets they are under those best to replace both at same time
SOURCE: 2005 chevy silverado won;t start.
i had the same problem, and it turned out the coil pack was moulding inside wich stopped the spark all together, i ended up changing my coil pack and putting on new wires because the ends connected to the coil were very corroded and that cures the not running part just fine
enjoy
SOURCE: how to replace the knock sensor on a 1999 chevy
The knock sensor is llocated on the left side of the engine block and is a single wire connector. Disconnect the wire and simply unscrew the sensor. Don't worry. There will be no fluid leaking. No tricks.
SOURCE: how do you replace the knock sensor on a 2005
The knock sensor should be on each side of the engine block. These are single wire connectors and require no special tools or tricks. Simply unscrew and install.
Testimonial: "you rock!"
450 views
Usually answered in minutes!
×