Scan first
do not play with these expensive parts
scan first.
if you ESD damage it , you'd be out, $1000 easy.
its not a blinker module like sold for $5
not close.
PCM 4x4 2.4L gas, usa.
The TCM is built into the PCM. Under the hood on the passenger side. Mounted to the fender. 4 plugs going to it.
This TCM is located inside the vehicle in the drivers foot well. remove the left kick panel, to the left of the brake pedal. The module will be mounted to the body and has 2 electrical connectors.
I’m happy to assist further over the phone at https://www.6ya.com/expert/nathan_cc888cf971f43e78
SOURCE: How to install the front license plate on the 2008
There should be guide holes in the bumper for you to mount the plate. It's recommended to mount a backing piece and then mount the place onto the backing for sturdiness. If there are no holes, you can just screw two holes into the bumper
SOURCE: location of cabin air filter
It can have a cabin air filter, but most vehicles ship without it.
Either way, you can access the cabin air filter housing by opening the glove box all the way (squeeze the sides so it clears the stops).
The filters are around $15 at the dealer.
Whether or not there's a cabin filter installed, make sure you're also
following Chrysler's recommendations in the owner's manual—running the
air on recirculate all the time will encourage mold and bacteria to
grow.
Good luck
SOURCE: like to know what tipe of antifreeze 2008 jeep
Your Jeep uses a H.O.A.T engine antifreeze that is pink in color. It is not recommended that you mix any other type of antifreeze with the H.O.A.T. Any Chrysler, Dodge or Jeep dealership stocks this type of antifreeze and it is sold already mixed with water. The cost is around $14.00 a gallon.
Do Not Mix any other antifreeze.
SOURCE: how do you reset change
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure."
Follow these instructions.
6,994 views
Usually answered in minutes!
×