I need a steering column schematic - 1992 Pontiac Bonneville

Question edited for clarity.

Check out the link, and especially the images tab.

https://www.google.com/search?q=2006+workhorse+chassis+steering+column+schematic

..

Question edited for clarity.
Question moved to Ford

Videos and schematics.

https://www.google.com/search?q=1990+Ford+truck+steering+column

..

https://www.generalmotorspartsonline.com/oem-parts/gm-steering-column-23381950?origin=pla

Hi

this is pretty close here but may not be the right one, the link should send you in the right direction..

later

j

www.fordification.com/partnos/steering-column.htm

Removal

1. Disconnect battery ground cable

1. Remove the steering column shroud
   

1. Remove two self-tapping screws that attach the multi-function switch to the steering column tube casting. Disengage multi-function switch from casting.

1. Disconnect the two electrical connectors, using caution not to damage the locking tabs. Do not damage PRNDL cable.
   

1
Steering Column 2
Screw 3
Multi-Function Switch 4
Wiring to Multi-Function Switch A
Tighten to 2-3 Nm
(18-27 Lb-In)


Installation

1. Install the two switch electrical connectors to full engagement. The wiring for the switch is to be routed under the PRNDL cable.

1. Align the mounting holes on multi-function switch with the holes in the steering column tube casting. Install two self-tapping screws making sure to start the screws in the previously tapped holes. Tighten to 2-3 Nm (18-27 lb-in).

1. For automatic transmission (7003), verify that the PRNDL adjustment is correct.

1. Install the steering column shroud.

1. NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more for powertrain control module to relearn the strategy.
   
2. Connect the battery ground cable.
   
3. Check the steering column tube for proper operation.
   

I hope this helps, if you have any questions just ask

it is in the fuse panel on the side of the dash as you open the drivers door,between the door panel and the very left side of the dash that is facing out when the door is opened,hope this helps.

steering columns are tricky bastards, even with schematic they are difficult ton rebuild, my advise is to carefully dissassemble and make notes, i have done many and you need patience, they only go back together one way and sometimes require installation of may parts at once and only in the proper order, have fun

If you intend to keep the vehicle long term, I would suggest you invest in a Haynes Manual, That is worth its weight in gold, for this and any other project..
Regards,DT

Are you asking for a mechanical steering wheel drawing or a wiring harness schematic?

ok there are 2 bolts under the dash 4 on the floor and the yoke your going to have to take off the plastics around the the collum ther are 4 screws and it comes off. there are two sets of electrical clips you will have to take apart you will see a little push clip and pull apart after that it will be free and slide right out. for the steering wheel there are 2 screws behind it that will take off the air bag and un plug it then one bolt and you will need a puller to take it off thats only if you want it.