Were is the timing mark on my 97 isuzu trooper v6

ok 97 trooper
its the one marked wiper.
dash fuse box.
C5
marked FRT wiper % washer

gee guy, 3.1L or 3.2L?
you only need 3 things to time the distrib. static.
where is #1, its the most forward cylinder, LOOK carefully.
forward means closest to the cam drive end of engine.
not flywheel end.
rotor rotation direction (crank and watch it)
now the order, 3.2l v6? IS It? the single cam?
1990 trooper v6
answering for only USA car...
our 3.2 has no distrib V6 its DIS.






3.1L V6 USA spec. only. rotor is CCW

Here are diagrams for the timing belts and the timing marks for replacing the timing belt on the 1998 Isuzu trooper. Hope this helps.

http://www.2carpros.com/diagrams/isuzu/trooper/1998

the timing marks are on the top (camshaft)and bottom (crankshaft)pulleys,but you may have to clean off the faces to see them,try using chalk.

1999 ISUZU TROOPER - V6 3.5L 3475cc GAS FI N 6VE1

Belt Routing Diagram - Multiple Accessory



From DAYCO catalogue.

Remember rated whit help, good luck.

cam timming is possibly out due to gear reduction set up in heads
suggest remove rocker covers and make sure cam lobes are in this possition as well as all other timming marks luckily these engines (V6) are free wheeling (wont bend valves) set up like pic below

On or near the receiver/dryer.

Sorry for the severe delay.
I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.

Click on the following direct Link. It has the Timing Belt Diagrams and Photos with Marks for the Camshaft and Crankshaft that you will need. It also has numerous other helpful diagrams, instructions and photo's for use.

Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/2002/make/isuzu/model/trooper/2002_isuzu_trooper_timing_belt_diagram_marks.htm

that motor should be a 3.2 litre... 6VD1 there are timing marks for the cams and crankshaft... one is to the left of the left cam... the other is to the right of the right cam.... and the marks for the crankshaft pulley are at the 9 and 3 position on a clock.

the 2.3 litre appears to be a single cam

Robert