No reason given, (crash?) or upgrading? what?
alldata.com covers this, why not just read the manual.
huh?
bumper skins off, then unbolt the obvious bumper bolts.
the skins on some years,need finder liners removed in front.
i have a 2008
your autobody shop can do it in 30m flat.
let them?
and watch em?
i have a real FSM book.
and have them on all cars owned ever,50 years. +
i dont need to beg for answers. unless lost in the book.
page 5104 covers this step.
ill paste them. the book has photos, and im not doing them.. ok.
Remove the push pin fasteners (2) and release the splash shield (1) from the bumper.
2. Remove the push pin fasteners (3) and remove the splash shield.
3. Disconnect the electrical connectors (1).
4. Remove the outer (4) and inner support bolts (2) and remove the front bumper.
out.
one of the most simple cars on earth to fix.
and for sure this....
is that clear?
SOURCE: 2007 jeep wrangler shakes uncontrollaby after
When you say shakes i am guessing the steering wheel. If it is the steering wheel shaking, it's know as the death wobble. Check the front steering components, look for worn or broken parts. Most common for death wobble are the tie rod ends, idler arm and pitmen arm. look for play along the track bars and check the ball joints. The other thing too that will cause a death wobble is a bad alignment. there may be negative or no caster at all which would give you a death wobble. Check all of the above and keep me posted. Good luck and be safe
SOURCE: How do I change the front bumper on a 2000 Jeep?
grab a hanes book my bumper on mine flung off like sling shot on my 96 it had plastic pegs held it on see if yours the same get the hanes book it helpfull
SOURCE: CHaging signal light in a 96 Jeep Grand Cherokee
Review this info: ZJ-Secc-8L-Lamps (page Lamps 8L-5 and next)
Good luck, and rated me!!!
SOURCE: remove 2007 jeep compass bumper cover
Hello, I can assist you. Begin by rounding up the necessary tools:
7mm socket and ratchet
7mm wrench
10mm socket
screw driver or panel removal tool (for push rivets)
Now go to the following site and take a look at the step by step instructions and pictures which does a nice job of explaining this entire job. Thanks for using Fixya!
http://www.jeeppatriot.com/forum/showthread.php?t=6291
SOURCE: 2006 jeep grand cherokee bumper removal
check your metal bumper retainers attached to the front chassis there must be a hidden bolts and nuts thats still on that you havent seen yet remove it and take off the bumper bar( steel bumper)
Testimonial: "Thanks for the response.."
88 views
Usually answered in minutes!
×