Turns over no spark
1 one spark plug or all 4? (key fact one missing)
insert honda OBD1 diagnostic jumper (or as FSM directs)
engage Diag mode.
then crank engine for 5 seconds.
then release key,
does the ECU flash out codes for a failure.,, BINGO
all cars work like this 1987 to now, USA>
what engine, of the many?
fsm quotes (and vast on line data same on all honda\'s)
there are more online facts on honda\'s than any car.
they race them and have hacked them to infinite levels.
now thequote
On 1990-95 Accord (except V-6) and 1992-95 Prelude, the codes are read from the check engine light after the two-wire service connector has been jumpered. On Accords, the service connector is under the dash on the passenger side. On Preludes, it is located behind the center console. Codes 1 through 9 are indicated by a series of short flashes; two-digit codes use a long flash for the first digit followed by the appropriate number of short flashes. For example, Code 14 would be indicated by 1 long flash followed by 4 short flashes. Codes are separated by a pause between displays. Multiple codes are transmitted in an alternating pattern. For example, a code 3 and 14 would be displayed as 3 short flashes (for Code 3) followed by the separator pause, then 1 long flash and 4 short flashes (for Code 14).
my comment, code 4 or 8 tells you , CKP or CMP sensors are dead.
in gringo that is "crank or cam sensors dead)
the ECU can report even , 1 in 10 pulses missing.
its very very , accurate in this report.
crank
release key
wait a minute to see if the ECU sets DTC errors.
do not turn off the key,or it erases them. wait, for 5min.
196 views
Usually answered in minutes!
×