2002 Dodge Intrepid Logo

Related Topics:

A
Anonymous Posted on Jul 12, 2014

What is P0068-MAF/MAP sensor throttle position correlation

1 Related Answer

ZJLimited

ZJ Limited

  • 17989 Answers
  • Posted on Mar 05, 2012

SOURCE: p0068 map/maf throttle position correlation

Hi there:Here's the printout from the diagnostic tool. Year: 2006Manufacturer: ChryslerMake: DodgeModel: DurangoEngine Type: V8, 4.7LTransmission: AutomaticTrim Level: SLTMileage: 127555 KMs
=== Stored Error Code(s) ===Error Code: P2074Possible Causes: Manifold Absolute Pressure/Mass Air Flow - Throttle Position Correlation at Higher LoadError Code: P0068Possible Causes: MAP / MAF - Throttle Position Correlation
Freeze Frame Information:1. DTC for which Freeze Frame was Stored - P2074.2. Fuel System 1 Status - Closed Loop.3. Fuel System 2 Status - Closed Loop.4. Calculated LOAD Value - 74.51 percent.5. Engine Coolant Temp - 199.40 degrees F.6. Short Term Fuel Trim - Bank 1 - -3.91 percent.7. Long Term Fuel Trim - Bank 1 - -3.13 percent.8. Short Term Fuel Trim - Bank 2 - 0.78 percent.9. Long Term Fuel Trim - Bank 2 - -4.69 percent.10. Intake Manifold Absolute Pressure - 22.21 Inhg.11. Engine RPM - 2,404.00 Rpm.12. Vehicle Speed Sensor - 73.94 Mph.13. Ignition Timing Advance #1 Cylinder - 25.50 degrees.14. Intake Air Temperature - 64.40 defrees F.15. Absolute Throttle Position - 31.37 percent.16. Time Since Engine Start - 1212 Sec.17. Commanded EGR - 7.06 percent.18. EGR Error - 0.00 percent.19. Commanded Evaporative Purge - 62.35 percent.20. Fuel Level Input - 93.73 percent.21. Barometric Pressure - 26.35 Inhg.22. Control Module Voltage - 14.35 V.23. Absolute Load Value - 0.00 percent.24. Commanded Equivalence Ratio - 0.00.25. Relative Throttle Position - 0.00 percent.26. Ambient Air Temperature - -40.00 degrees F.
Monitor Information:1. MIL - OFF.2. Misfire Monitor - Complete.3. Fuel System Monitor - Complete.4. CCM Monitor - Complete.5. Catalyst Monitor - Complete.6. Heated Catalyst Monitor - Not Supported.7. EVAP Monitor - Complete.8. Secondary Air System Monitor - Not Supported.9. O2 Sensor Monitor - Complete.10. O2 Sensor Heater Monitor - Complete.11. EGR Monitor - Complete.12. NMHC Monitor - Not Supported.13. Nox Adsorber Monitor - Not Supported.14. Boost Pressure System Monitor - Not Supported.15. Exhaust Gas Sensor Monitor - Not Supported.16. PM Filter Monitor - Not Supported.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using FixYa.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

P0068 P0306 P0449 Why are all on at same time 2007 GMC Yukon

code p 0306 is --misfire on no 6 cylinder ===causes injector wiring ---ht leads , coil
code p 0449 is EVAP purge valve --circuit malfunction ===causes --wiring--EVAP canister purge valve --ECM and code p 0068 is MAP ( manifold pressure )sensor ( mass air flow sensor (MAF)---throttle position correlation===causes --wiring--MAP/MAF sensor--mechanical fault
could be a common wiring harness plug connection or loose connections on the ECM
0helpful
1answer

P0068 and p0102 and p0113 suburban 2007

P0068 MAP/MAF manifold absolute pressure/mass airflow throttle position correlation
0helpful
1answer

04 ram has 2 codes p0068 p0175

Here's a link to the P0068 code. P0068 MAP MAF Throttle Position Correlation Here's the link to the P0175 CODE. P0175 OBD II Trouble Code
0helpful
4answers

Engine runs rough and stalls sets a p0068 code on a 05 dodge durango

P0068-MAMFQLD PRESSURE/THROTTLE POSITION CORRELATION
' Image
Theory of Operation
This DTC sets when an unexpected high intake manifold air flow condition exists that
can lead to increased engine speed and puts the NGC into a High Air flow Protection
limiting mode. The High Air flow Protection feature includes RPM limits for when a
Throttle and or MAP sensor limp-in fault is present.
When Monitored
During all drive modes.
Set Condition
If vacuum drops below 1.5Hg with engine RPM greater than 2000 RPM and closed
throttle. One Trip Fault. Three good trips to turn off the MIL.
Possible Causes
-VACUUM LEAK
-RESISTANCE IN THE (FS56) 5-VOLT SUPPLY CIRCUIT
-(FS56) 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND
-RESISTANCE IN THE (Kl) MAP SIGNAL CIRCUIT
-(Kl) MAP SIGNAL CIRCUIT SHORTED TO GROUND
-RESISTANCE IN THE (FS55) 5-VOLT SUPPLY CIRCUIT
-(FS55) 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND
-RESISTANCE IN THE (K22) TP SENSOR NO. 1 SIGNAL CIRCUIT
-(K22) TP SENSOR NO. 1 SIGNAL CIRCUIT SHORTED TO GROUND
-RESISTANCE IN THE (K900) SENSOR GROUND CIRCUIT
-MAP SENSOR
-THROTTLE POSITION SENSOR
-PCM
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
25312083-mkm0xbqveb5zta3uncrswycs-5-0.png Auto Repair Help US 25312083-mkm0xbqveb5zta3uncrswycs-5-2.jpg
0helpful
1answer

P0123 and p0068 on a dodge durango 2007

P0068 - MAP/MAF Throttle position correlation
P0123 - Throttle positon sensor/Swtch A Circuit high input
2helpful
1answer

Get codes p0068 and p0108

codes p0068 refer to Manifold pressure sensor/mass air flow sensor--throttle position correlation--causes ---wiring---map sensor---maf sensor--mechanical fault.
code p0108 refers to manifold absolute pressure(map) sensor/barometric pressure (BARO) sensor--high input. causes ---wiring short to positive---map sensor---baro sensor---ecm.
0helpful
1answer

I have a 2006 hummer h3 that starts and runs as long as you are real easy with it if you try to accelerate heavy it will boag out and die I have eliminated the fuel pump and the only code showing is P0068...

Your truck is what is known as drive by wire. There is not a physical connection between the pedal and the throttle body. Your throttle position sensors are not talking to each other.
1helpful
1answer

Dodge durango p0068

maf/map sensor throttle position correlation. actron computer hooked up to my durango gave me that code you can look them up
2helpful
2answers

Check engine light

P0113 Intake Air Temperature Circuit High Input
  • P0123 Throttle Position Sensor/Switch A Circuit High Input
  • P0068 MAP/MAF - Throttle Position Correlation

  • P0108 Manifold Absolute Pressure/Barometric Pressure Circuit High Input
    Have u had any work done on the engine lately or anything done under the hood? looks like something in the area of the MAF sensor is disconnected or the sensor itself is disconnected, all the codes are related.
  • 0helpful
    2answers

    2006 Dodge Stratus

    I dont know if this helps any but I found a website that lists dodge codes. Unfortunatley all it says is "MAP/MAF-Throttle position correlation" Sorry I don't have more to offer. Good luck
    Not finding what you are looking for?

    214 views

    Ask a Question

    Usually answered in minutes!

    Top Dodge Experts

    ZJ Limited
    ZJ Limited

    Level 3 Expert

    17989 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6988 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    15088 Answers

    Are you a Dodge Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...