Having a no crank no start so click issue in a 1994 mercury tracer. Need help please.

SOURCE: 1994 Tracer

usually a surefire way to check the problem is first check the fuel pump relay.when you turn the key you should hear the relay click(they are located underneath the center console on the passengerside) if the relays are good, then check the fuel shutoff switch to see if it was triggered(this is located on the passenger side in the rear wheel housing,there is a little pull off panel and it's marked.press the reset button on top if it's tripped. If you still have a problem the othere things to check are the firing of the plugs if there is fire your fuel pump is bad,if not you eithere have a bad coil pack or a timing belt issue

SOURCE: serpentine belt for 1998 mercury tracer

Hey there MSM,

• Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar.
• Get the belt around all the pulleys except the A/C compressor or Alternator. The routing diagram is on one of the radiator supports.
  
• The tensioner pulley is near the Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley.
• Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley.
  
• Slowly release the tension.
  
• You're done

Marvin

• 85242 Answers
• Posted on Jan 24, 2009

SOURCE: where is ecm box located on 99 tracer mercury

It is located under the dash, directly in front of the center floor console. The easiest way to access is to remove the console, which is very easy to figure out and do. The console is only held in place with about 6 phillips head screws

SOURCE: 1994 mercury tracer wagon rear driver strut rusted through

buy a chevy lol

ZJ Limited

• 17989 Answers
• Posted on Jul 21, 2010

SOURCE: belt routing diagram for 1997 mercury tracer?

Check this...



Hope helps.