94 Dodge Ram 360
Belt is stretched or jumped a tooth ahead.
The main crank bearing thrust washer (rear bearing)
face is worn ,for any number of reasons
The only fix is to remove the motor & change
the main bearings.
How do you know it is not just a failed crank damper
pulley, that is causing the misalignment issue,could be both
I guess
If the crank is walking, then your possibly going to also have
transmission torque converter problems or flywheel breakage
SOURCE: Need diagram/schematic for serpentine belt replacement
Should be a tag on the core support somewhere that shows a diagram how to install your belt,usually its right on top where the radiator bolts to core support,open hood look down on top of support or its on the inside of hood open hood and look up see if theres a tag with a diagram of belt installation
SOURCE: 1994 Dodge Ram 1500 5.9 (360) won't start new fuel pump, coil??
Maybe check ignition control modual.
SOURCE: 1999 Dodge Ram 360 5.8 liter engine feels like transmission is sl
Hi, the problem you are having sounds like the differential needs replacing this can be expensive and hard work but not doing this can cause further damage to your vehicle so its better get it done sooner rather than later.
If on the other hand your only getting a vibration through the steering wheel then this could be that the wheels need balancing.
You should know which of the two problems you have if you need further assistance then just let me know ok
SOURCE: I need belt diagrams for a 1991 Dodge Ram Van
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.
CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/1991/make/dodge/model/ram_van/1991_dodge_ram_van_drive_belt_routing_diagram.htm
SOURCE: Need diagram/schematic for serpentine belt replacement
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I have only been a free contributor to this site for the past 4-months.
I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.
CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/1998/make/dodge/model/ram_van/1998_dodge_ram_van_drive_belt_routing_diagram.htm
You can find one at autozone.com, you may have to sign up for a free account, but you can view the job diagram there. It looks like for a 6 cylinder, there are two belts, one goes from the crank pully around the water pump then the alternator, and the other goes around the crank shaft then the power steering pump and then the air compressor pully. The power steering and air is a "v" belt and the other is a ribbed serpentine belt. they both just wrap around no wierd routing. the only thing I do not see is the idler pully or tensioner pullys.
102 views
Usually answered in minutes!
×