Question about 2002 Toyota Sienna
Posted by Anonymous on
I don't think that the solenoid is available separately from the starter motor for this model. A remanufactured starter motor for an 02 Sienna should be easy to acquire through a local auto parts shop for just over $100. You may have to be a contorsionist to get to it, though in the relatively small engine bay.
Posted on Jul 16, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
this sounds correct, however, if you go to autozone.com, the have access to free online manuals, giving you step by step instructions on how to remove. you will need to register and provide some info about your vehicle. it is FREE! the manuals are in the do it your self area. Good Luck!
Posted on Sep 13, 2009
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
Posted on Sep 29, 2009
Try this.....Find the latch on the door, stick your finger in the hole, lift up and pull the door handle at the same time, the inside latch mechanism should go up, then try the door again. It would be nice if that's all it was huh? Sometimes they stick when they get too cold. If this works for you....spray it with some WD-40 or graphite. Hope this worked for you. Cheaper than the 2000.00 motor!
Posted on Feb 05, 2010
If you have the HID bulbs, and there is moisture in the bottom of the assembly, the high voltage box at the bottom will not work. this requires removing the whole headlamp, removing the circuit board from the bottom and drying out. I have done mine twice before finally finding how water was getting in at the top seam of the lamp assembly. You will have to dis-assemble part of the wheel well and bumper cover to gain access to all the mounting bolts. Best of luck
Posted on May 02, 2010
Tips for a great answer:
Jan 12, 2015 | 2004 Toyota Sienna
Nov 20, 2014 | 2004 Toyota Sienna
Nov 10, 2014 | 2004 Toyota Sienna
Mar 19, 2013 | 2006 Toyota Sienna
Feb 10, 2013 | 2006 Toyota Sienna
Jan 29, 2013 | 2004 Toyota Sienna
May 13, 2012 | 2009 Toyota Sienna
Apr 03, 2012 | 2004 Toyota Sienna
Feb 01, 2012 | 2007 Toyota Sienna
Dec 19, 2011 | 2006 Toyota Sienna
Nov 04, 2016 | 2002 Toyota Sienna
185 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: