Tow haul switch

Tow/haul mode enables the operator to achieve enhanced shift performance when towing or hauling a load. When tow/haul mode is selected, the tow/haul switch input signal to the body control module (BCM) is momentarily toggled to zero volts. This signals the powertrain control module (PCM) to extend the length of time between upshifts and increase transmission line pressure. Cycling the tow/haul switch again disables tow/haul mode and returns the transmission to a normal shift pattern.

Would't trust it , take an have DTC'S - diagnostic trouble codes checked by a qualified repair shop with a factory or professional scan tool . Auto part stores can not check BCM code's .
DTC B2722

Tow/Haul Switch/Indicator Always On or Inoperative

Step
Action
Value(s)
Yes
No
1
Install a Scan Tool .
Turn ON the ignition, with the engine OFF.
Cycle the tow/haul switch while observing Tow/Haul Mode on the Scan Tool .
Does the Scan Tool display Active when the switch is first pressed, and then Inactive when the switch is pressed again?
--
Go to Intermittent Conditions in Engine Controls - 4.3 L or Intermittent Conditions in Engine Controls - 4.8 L, 5.3 L and 6.0 L
Go to Step 2

You need to have a diagnostic scan tool hooked up ,glitch in one of the control modules or a wire in the circuit shorting to ground ! probably something simple but hard to find ! With a factory scan tool they can check the input signal to the BCM ,PCM .
Tow/Haul mode enables the operator to achieve enhanced shift performance when towing or hauling a load. When tow/haul mode is selected, the tow/haul switch input signal to the body control module (BCM) is momentarily toggled to zero volts. This signals the powertrain control module (PCM) or transmission control module (TCM) to extend the length of time between upshifts and increase transmission line pressure. Cycling the tow/haul switch again, or cycling the ignition switch disables tow/haul mode and returns the transmission to a normal shift pattern.

Mine was probably some kind of sweet drink. Works like glue when it dries. Had to remove the button from the switch assembly and clean with Windex. 1 hour. 2012 Jeep KK.

Th e tow haul button is so if your towing a heavy trailer its easier on the tranny when you hit the button you generally dont need to use it for everyday regular driving.

could be the switch or modual.check wiring for worn through or earthing.

Pull shifter boot-ORANGE wire which runs from Tow/Haul button down column-when the steering column is adjusted this wire will get pinched. Take a look-it took me six months to figure this out-thanks to NO help from GM.

on shifter tow haul button could be causing problem

most likely switch

I had a problem with my tow/haul button not working. I came to find out that the gear shift had cut the wire running to the button in two. You may want to check that.

Hi, the problem is when you are tilting the steering wheel all the way up it's putting to much tenstion on the wires that come outof your shifter that run to the tow/haul button. i am 99% sure your wires are disconected. rewire them and add some extra wire so next time there will be more slack in your wires.