How do I remove the front grill - 2005 Toyota LandCruiser Prado

In the 2013 Chevrolet Avalanche, the horn is located behind the front grille on the driver's side of the vehicle.

To access the horn, you'll need to remove the front grille. Here are the general steps to removing the front grille:

1. Open the hood of the vehicle and locate the clips that secure the top of the grille in place.
2. Use a flathead screwdriver to gently pry up on the clips and release them.
3. Locate the bolts or screws that secure the bottom portion of the grille to the vehicle's frame.
4. Use a wrench or socket set to remove these bolts or screws.
5. Once all the fasteners have been removed, gently pull the grille away from the vehicle.

With the grille removed, you should be able to access the horn and inspect it for any damage or issues. If you need to replace the horn, you can do so by disconnecting the wiring harness and removing the mounting bolts that hold it in place.

Check out the videos. Must be easy as the videos as short.

https://www.google.com/search?q=2001+Volvo+S80+remove+the+front+grill

..

https://www.chryslerminivan.net/threads/grill-removal.167059/

Videos

https://www.google.com/search?q=remove+front+grille+on+a+2016+Dodge+Grand+Caravan

..

The grill is one part mounted to the front clip.
I removed the whole front clip & headlights. But I was making other mods at the time.
Get one of those cheap sets of plastic trim removal tools, there are these wedged in clips along the bottom of the grill that are difficult for the pros todo right and they are fragile so be patient
open hood
remove the 7 bolts and 2 pop in rivets directly on top of grill
pull the top of grill out enough to get a hand with a wrench in there for the other bolts, holding the grill to the front clip
stuff a rolled towel between the grill and front clip on the left side
using a trim tool or flathead pry up to push these clips down a bit and it will slide out the towel will keep pressure on it so it won't go back in while you move left to right prying the clips add a rag between the grill & front clip on the very left edge just enough to keep those clips from resetting and it will pop right off.
Have a shop light facing the grill and be patient.
installing just line up those lower clips and and bump it with a mallet they pop in easy. Good Luck I love me some Ford!
https://www.explorerforum.com/forums/index.php?threads/2011-grill-removal-with-pictures.415328/

Remove wheels. Remove fender liners front. Remove three nuts per side from inside fender wells. Remove fog lamp grilles. Remove vertical bolt just inside grilles--pointing up. Remove two screws per side under hood near front of fender. Put milk crate under front bumper. Remove belly pan first. Slide bumper forward onto milk crate, disconnect headlight washer line at quick disconnect if so equipped. Disconnect fog light connectors. Remove bumper.

Behind the grille, here's how to remove it to expose horn Thread How To Bumper Removal for Protege5 pics

Hi,
I have no idea how to remove the front grille of Octavia but to solve out your problem I found out one video which is showing to replace the new front grille with old or damage one. May this video helps you. Have a look

Trooper
See Figures 3, 4 and 5



Fig. 3: Front grille assembly-1984-94 Trooper



Fig. 4: Front grille assembly-1995-96 Trooper



Fig. 5: Retainer clip used to secure the front grille

1. Raise the hood and support it with the prop rod.
2. On 1981-94 models, remove the retainer screws from around each headlight.
3. Remove the retainer screws from the corners and center of the grille.
4. Using a small prytool to press the tab on each of the grille retainer clips at the top of the grille upward while pulling the grille away from the radiator support.
5. When all the tabs have been released, lift the grille up slightly and out to remove.

To install:

1. Engage the lower portion of the grille into the radiator support.
2. Carefully push the grille toward the radiator support, making sure the retainer clips align with their respective mounting hole. Once all the holes align, press the grille and retainer in until it clicks into position.
3. Install the retainer screws from the corners and center of the grille.
4. On 1981-94 models, install the retainer screws around the headlight.

Hope helps (remember rated this).

This is out of my 06 Murano manual, hope that it helps.

REMOVAL
1. Apply protection tape around outer circumference of front grille (bumper fascia side).
2. Remove front grille-radiator cover clips and remove front grille-radiator cover.
3. Remove clips on upper side of front grille.
4. Remove clips of air duct and remove air duct. Refer to EM-16, "AIR CLEANER AND AIR DUCT" .
5. Pull out grille pawls, and remove front grille assembly.

Installation is the reverse of removal.

good luck

the lower clips are pushed down with a long screw driver from the front , when the grill is removed the clips need to be removed from the vehicle and put in the grill then push the grill in