Change water pump oil is mixing with water
SOURCE: how to change water pump
Well, waterpump on your car is internal inside the timing chain area, being driven by the timing chain. You need to remove drive belts, the small black side covers, that are screwed into the front engine cover. The left on has the chain tensioner, the right one has the water pump behind it. Once the covers are removed, you need to push the timing chain tensioner inside and put a pin inside of it (tensioner ) to hold it in. Once you have done that, you need to rotate the engine counterclockwise (until you feel tension) to loosen the chain around the water pump. Then you will use 2 bolts (6mm and about 2 inches long) and screw those into the water pump body. This will pull the pump out of the engine, so pretty much the bolts are going to be acting as puller device to remove pump out of engine. reverse install procedure. This is not the easiest of repairs and not for a novice or someone, that doesn't really work on cars. Good luck.
SOURCE: oil filter won't screw on to oil pump
you need to get the filter made for your car never mix parts unless its designed for that car with out the correct filter not much you can do
SOURCE: i have a 1995 nissan pick-up i need to change out
When you take the fan clutch off the pulley comes off with it.
SOURCE: after i changed the water pump in 1995 nissan
I HAVE A WATER PUMP THAT IS NOT WORKING AND THE MECHANIC SAID TO REPLACE WATER PUMP I HAVE TO REPLACE HEAD GASKET AND TIMING CHAIN. DO I HAVE TO?
SOURCE: How do you change the water pump on a 1995 nissan
Water Pump
REMOVAL & INSTALLATION
VG30E Engine
The water pump is located in the front center of the engine.
Fig. 1: The timing belt cover must be removed to fully access the water pump
NOTE: Be careful not to spill coolant on the timing belt when performing this procedure.
VE30DE Engine
The water pump is located in the front center of the engine.
Fig. 2: Water pump location and torque specifications — VE30DE engine
Never open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Also, when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantities. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old.
Never open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Also, when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantities. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old.
NOTE: It is recommended that the crankshaft damper be removed to make water pump removal and installation easier.
Failure to install the bolts of different lengths in their proper locations could result in a cracked timing chain cover, requiring time consuming and costly repair. Be sure to label each bolt and its location.
Fig. 7: Use locking pliers and carefully twist out the timing pointer if pump removal is difficult
To install:
287 views
Usually answered in minutes!
×