Remove and replace serpentine belt for Honda CRV that Drives the waterpump/power steering/alternator/AC compresser and ideler pulley
The parts store you purchase belt from should be able to give you the routing.
SOURCE: serpentine belt
This is a picture i drew in paint , for the 2001 honda passport belt wrap with a 3.2Liter V6, picture worth a thousand words.
SOURCE: how to change a serpentine belt for a 2004 honda
pull up on thr idler pulley with a good solid metric wrench and slide it off, once off, check all your pullys for lose bearings especially the alternator...replace the belt too while you at it.
SOURCE: how do you replace a 2004 honda crv serpentine
You will need a serpentine belt tool to do the job properly. You attach it the the belt tensioner, and pull it to loosen up the belt.
SOURCE: location of Idle control valve on 04 CRV
It's not a easy job but I'm pretty sure you had one of those problems where the idle surges if this is the case take out the air intake tube that leads to the throttle body, get a can of carburetor fluid and spray around the throttle body. You will need someone to start the car and hold the gas peddle to 2500 rpm while you do this the car will shut of when you do this, restart the car and repeat the process until half of the can is used up. Now check your antifreeze level fill if needed and reset you check engine light. Now you can take the idle air back and get your money.
2,575 views
Usually answered in minutes!
×