2003 Nissan Altima Logo
Anonymous Posted on Jun 30, 2009

03 Altima 2.5, Wont turn over on cold start

I have a 2003 Altima 2.5, just hit 70k. On a cold start, it takes about 10 to 15 minutes to get the engine to turn over. It just cranks and cranks and cranks and eventually it starts. During all the cranking it turns over a couple times for a few seconds and seems to be misfiring and then it dies again. Check engine error read bad crank sensor, so I replaced it. Problem still persists. Then check engine error read bad cam sensor, so I replaced that as well. Problem still persists. I have changed the spark plugs, and all the ignition coils are new. A friend suggested that it may be a check valve in the fuel pump. Anyone have any other suggestions? Your input is greatly appreciated.

  • Anonymous Jul 06, 2009

    I played around with the fuel pump and i got the problem to go away for a few days, but now it's starting to happen again. Looks like I'm going to be replacing that pump. Thanks for the help!

×

1 Answer

Dar

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Nissan Master 2,007 Answers
  • Posted on Jun 30, 2009
Dar
Nissan Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Feb 18, 2009
Answers
2007
Questions
1
Helped
733709
Points
6454

First, change the fuel filter, and make sure the lines are good. Check the intake manifold bolts for tighness, check all vacuum lines. Best to have it running, wiggle them around and listen for a hiss. Lastly, change idle control sensor, if the other suggestions don't make a difference.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
1helpful
1answer

03 eclipse making noises in cold weather

First you need to find the source that is causing noise. On cold weather is very normal engine belts or belts idle pulley bearings or belt tension-er to make noise, especially when they are old. Also power steering pump too especially if the oil is very old.
5helpful
2answers

2003 altima hard to start when engine is warm

replace coolant temp. sensor , disconnect coolant sensor plug after engine is at running temp. ,shut engine off then restart ,if engine starts fine, replace coolant sensor
0helpful
1answer

This morning it was very difficult to start my 03 Passat

VAG suffer greatly with a signal failure to ECU that brings the choke on when cold. Your fault is text book of this.

Follow the top radiator hose to where it meet the engine, at that point you will see a sensor, it has 4 wires and is held in by a horseshoe clip. This is the water coolant sensor, replace it and you'll be happy again :o)
3helpful
2answers

I have an 03 nissan altima engine makes loud clicking noise

1st check the the oil level and the vehicle's oil type.(owners manuel) 5w30-10w30
10w 30 is a thicker oil and could possibly be causing this.(Moves more freely through the engine heats the oil)
0helpful
1answer

Sometimes it wont kick in 2nd gear.(20 mph)

it maybe a pluged tranny line did you get it flushed?? a little metal shavings might have made there way up there and caused a block so get that checked
5helpful
1answer

2003 Nissan Altima heat problems

take to dealership , that also is a recall problem with alot of altimas , they need to flush system and check water valve , got mine fixed working great ever since , never hesitate to ask dealership about recalls , they have to fix for free
0helpful
1answer

Jeep Wrangler 03 A/C stopped working abruptly

This may be the AC compressor cycling switch is defective. It is located in the larger of the 2 AC lines coming from the compressor, it has a wire connector to it with 2-3 wires. To verify this is the issue jumper the connector with a small piece of wire and see if the compressor runs.
Not finding what you are looking for?

674 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...