Why when i drive like stop and go my dash dials dip as if the power is being drained, but when the car stand and idles and this day or night time but my battery is always strong and the car starts up one time even if i drove the whole night plus my headlights only works on hi beam

DRL - day time running lamps , lets get this stright , When your daytime driving lights are on the dash lights go off . An it's daytime ? If it were night an the regular headlamps were on are the dash light's on then ? Becaused if the daytime running lamps are on an it's day time , why would the dash light's be on ? You wouldn't need the dash lights in day time light conditions . No problem !

YOU FIRST YOU NEED TO REMOVE COOLANT RECOVERY RESERVOIR. YOU NEED TO REMOVE DRIVE BELT.NOW PLACE DRAIN PAN UNDER CAR IN LINE WITH POWER STEERING PUMP.NOW SIPHON OUT MUCH POWER STEERING FLUID OUT RESERVOIR USING A SIPHON.ONCE FLUID REMOVE OUT POWER STEERING PUMP.USE A DEEP 3/8 SOCKET ABOUT 13M OR 14 M YOU NEED A SHORT EXTENSION AND A 3/8 RATCHET WRENCH.TO REMOVE POWER STEERING PUMP.TO LOOSEN BOLTS, TAKE DEEP SOCKET IN PULLEY HOLES . LOOK THROUGH POWER STEERING PULLEY HOLES ALIGN DEEP SOCKET THROUGH THE PULLEY HOLES TO THE PUMP BOLTS. LOOSEN ALL THREE BOLTS. YOU HAVE TO TURN PULLEY THREE TIMES TO REMOVE ALL THE POWER STEERING PUMP BOLTS.ONCE POWER STEERING PUMP BOLTS REMOVED.TAKE OLD POWER STEERING PUMP TO THE MACHINE SHOP.THEY WILL HAVE TO REMOVE PULLEY OFF OLD PUMP AND TRANSFER DRIVE PULLEY TO NEW POWER STEERING PUMP.NOW WHEN YOU INSTALL NEW POWER STEERING PUMP.MAKE SURE TO BUY A NEW O RING FOR THE HIGH PRESSURE HOSE TO POWER STEERING PUMP. WHEN ALL DONE BLEED POWER STEERING PUMP. WITH THE FRONT WHEELS TURNED ALL THE WAY TO THE LEFT AND THE IGNITION KEY OFF, CHECK THE POWER STEERING FLUID LEVEL AND IF LOW ADD FLUID UNTIL IT REACHES THE COLD MARK ON THE DIP STICK.SAFELY RAISE FRONT WHEEL OFF GROUND BY SUPPORTING FRONT OF THE CAR USING JACK STANDS, MAKE SURE CAR SITTING ON SOLID LEVEL GROUND. START THE ENGINE AND ALLOW IT TO RUN AT FAST IDLE.RECHECK THE FLUID LEVEL AND ADD MORE IF NECESSARY TO REACH THE COLD MARK ON THE DIP STICK.BLEED THE SYSTEM BY TURNING THE WHEELS FROM SIDE TO SIDE WITHOUT HITTING A STOPS.THIS WILL WORK THE AIR OUT OF THE SYSTEM. DONT ALLOW THE RESERVOIR TO RUN OUT OF FLUID. WHEN AIR IS WORKED OUT OF THE SYSTEM.RETURN THE WHEELS TO THE STRAIGHT AHEAD POSITION, AND LEAVE THE ENGINE RUNNING FOR SEVERAL MINUTES BEFORE SHUTTING OFF. RECHECK THE FLUID LEVEL.ROAD TEST THE VECHICLE TO BE SURE THE STEERING SYSTEM IS FUNCTIONING NORMALLY WITH NO NOISE.RECHECK THE FLUID LEVEL TO BE SURE ITS UP TO THE HOT MARK ON THE DIP STICK WHILE THE ENGINE IS AT NORMAL OPERATING TEMPERATURE ADD FLUID IF NECESSARY.

FIRST OF ALL TURN OFF RADIO REMOVE NEGATIVE BATTERY CABLE. THEN REMOVE POWER STEERING PUMP FLUID FROM POWER STEERING PUMP.USING A HAND PUMP SIPHON. BE CAREFUL DONT GET POWER STEERING FLUID ON CAR PAINT IT WILL DAMAGE PAINT JOB.PUT A DRAIN PAN UNDERNEATH CAR TO CATCH POWER STEERING FLUID THEN DISCONNECT POWER STEERING PUMP LINES.REMOVE POWER STEERING PUMP ADJUSTER BOLT AND MOUNTING BOLT.REMOVE POWER STEERING PUMP.MOST OF THE TIME NEW POWER STEERING PUMP DONT HAVE DRIVE PULLEY ON IT SO TAKE TO A MACHINE SHOP THE WILL REMOVE PULLEY FROM OLD PUMP AND PRESS ON THE PULLEY TO NEW POWER STEERING PUMP.BESURE TO BUY NEW O RINGS TO END OF PRESSURE LINE.ONCE NEW POWER STEERING PUMP HAS PULLEY IN PLACE AND YOU HAVE NEW O RING FOR HIGH PRESSURE LINE.INSTALL NEW PUMP.ADJUST BELT TENSION.NOW BLEED POWER STEERING PUMP WITH FRONT WHEELS POINT STRAIGHT A HEAD POSITION.POUR POWER STEERING FLUID IN PUMP UNTIL FLUID LEVEL ON COLD MARK ON POWER STEERING PUMP DIP STICK.KEEP ADDING FLUID UNTIL FLUID STOP DROPPING. START THE ENGINE LET IT RUN AT IDLE ADD MORE FLUID IF DROPS KEEP FLUID ON FULL COLD MARK.ON DIP STICK TURN OFF ENGINE.CHECK TO MAKE SURE POWER STEERING PUMP NOT LEAKING AT THE LINES THEN.SAFELY RAISE SUPPORT FRONT OF THE VECHICLE WITH JACK STANDS. MAKE SURE VECHICLE ON SOLID LEVEL GROUND CHECK.FLUID LEVEL MAKE SURE AT FULL COLD MARK. NOW START ENGINE.LET IDLE MINUTE.THEN TURN STEERING WHEEL ALL THE WAY TO THE LEFT TO RIGHT SEVERAL TIMES WITH OUT STOPPING IT IN PLACE. CHECK POWER STEERING FLUID WHEN FLUID LEVEL STOP DROPPING.AND FLUID IS NOT A TAN COLOR WHICH MEAN LOTS OF AIR IN SYSTEM. TURN OFF CAR UNTIL AIR BUBBLES DISAPPEAR.CHECK FLUID LEVEL BLEED POWER STEERING AGAIN. DONT DRIVE VECHICLE UNTIL STEERING FEEL NORMAL.IF FLUID REMAIN TAN WITH AIR BUBBLES CHECK FOR LEAKS AT POWER STEERING PUMP PRESSURE HOSE ORING. AND CHECK POWER STEERING LINES TO PUMP FOR LEAKS.

TO DO A TRANSMISSION FLUID CHANGE YOU NEED HAVE TRANSMISSION FLUID ON HAND YOU NEED TRANSMISSION FILTER AND GASKET.YOU NEED 3/8 WRENCH THE RATCHET TYPE WITH METRIC SOCKETS. YOU NEED JACK TO RAISE VECHICLE SUPPORT VECHICLE ON JACK STANDS.YOU NEED A DRAIN PAN. ONCE YOU GET VECHICLE OFF GROUND.PLACE DRAIN PAN UNDER TRANSMISSION OIL PAN REMOVE OIL PAN DRAIN BOLT.LET FLUID DRAIN OUT IN DRAIN PAN THEN SCREW DRAIN PLUG BACK IN PLACE DONT OVER TIGHTEN.REMOVE OIL PAN AND GASKET. BESURE TO HAVE PAPER TOWEL ON HAND.MAKE SURE TRANSMISSION OIL PAN GASKET SURFACE CLEAN BEFORE INSTALLING NEW PAN GASKET. ONCE TRANSMISSION OIL PAN REMOVED. REMOVE THE OLD TRANSMISSION FILTER INSTALL THE NEW FILTER.THEN WITH NEW GASKET ON OIL PAN IN PLACE.OIL PAN NEED TO BE CLEAN SO THE GASKET ADHESIVE WILL HOLD PAN GASKET IN PLACE WHILE INSTALLING PAN AND GASKET TO TRANSMISSION.INSTALL OIL PAN BOLTS INSTALL THEM CRISS CROSS TORQUE PAN BOLTS TO 7 TO 10 FT LBS. LOOK IN OWNERS MANUAL FOR TRANSMISSION FLUID CAPACITY.BUY 10 QUARTS .TO BE ON SAFE SIDE SO YOU WILL HAVE ENOUGH FLUID ON HAND. IF YOU DONT HAVE NO TRANSMISSION FLUID CAPACITY. ADD 7.5 QUARTS FLUID.WAIT FOR 2 MINUTES.CHECK TRANSMISSION FLUID LEVEL ON DIP STICK. SHOULD BE ON THE FULL MARK.CRANK VECHICLE UP.LET IDLE FEW MINUTES CHECK TRANSMISSION DIP FLUID LEVEL IF DROPPED ADD LITTLE MORE.WHILE ENGINE IDLING GETTING WARM UP. KEEP EYE ON FLUID LEVEL.WHEN FLUID LEVEL STOP DROPPING. APPLY BRAKES HOLD FOOT ON BRAKES SHIFT THROUGH ALL GEARS TWO TIMES. THEN CHECK FLUID LEVEL SHOULD BE ON FULL MARK.CHECK FOR LEAKS WHILE ENGINE RUNNING.

YOU NEED TO BLEED POWER STEERING SYSTEM BY HAVING LOW FLUID AIR ENTER THE SYSTEM.PARK CAR ON SOLID LEVEL GROUND SAFELY RAISE SUPPORT VECHICLE ON JACK STANDS.YOU CAN LEAVE CAR ON GROUND BUT TURNING STEERING WHEELS BACK AND FORTH WILL WEAR SPOT IN TIRES.TURN STEERING WHEEL TO THE LEFT WITH THE ENGINE OFF.CHECK POWER STEERING FLUID.ADD MORE FLUID IF LOW.MAKE SURE FLUID LEVEL ON COLD MARK ON DIP STICK.THE YOU CRANK CAR UP LET IDLE LITTLE HIGH FOR 15 SECONDS.THEN TURN OFF ENGINE.CHECK POWER STEERING FLUID LEVEL MAKE SURE ITS ON COLD MARK AT DIP STICK.THEN YOU START THE CAR UP WHILE IDLING TURN STEERING WHEEL IN BOTH DIRECTIONS SLOWLY TO THE STOPS DONT HOLD IN STOP TURN STEERING WHEEL LEFT AND RIGHT FOR SEVERAL TURNS.STOP ENGINE CHECK FLUID IF FLUID TAN STILL HAS AIR IN SYSTEM.LET CAR SET A LITTLE WHILE TRY THE BLEEDING PROCEDURE AGAIN.THERE IS A REASON POWER STEERING FLUID WAS LOW CHECK ALL POWER STEERING HOSES AT POWER STEERING PUMP TO THE RACK PINION ASSEMBLY.

thats standard on that car swedish law have to drive on dipped lights day and night

Make sure you are not checking the oil with the car running first of all, second don't check the oil immediately after turning off the car let the engine stand for about ten minute allowing the oil to drain off the dip stick,

frist check your wires then have you aternater check ok you may have got a bad one

Could br the light switch is bad.

Change the fuel filter. An put some injecter cleaner in it. With some good gas.Then hit thr highway an blow it out.Not to fast. lol