How to replace the ac compressor clutch on a 2000 gmc yukon xl?

SOURCE: Oil Pan Gasket Replacement - How to - GMC Yukon 2000

No big job Really. Just locate your Drain Plug for the Oil. Thepan is right there, Remove the Bolts around the Pan and Remove. You will lose all of your oil so, Have something there to catch it all. Clean it all around the Edges of the Block where the Pan mounts with Degreaser and Make sure that you Scrape the Old Gasket off of Both the Block and the Pan. Run a Thin Bead of Blue ATV Silicone around the Pan Edge, Lay the Gasket on top of this Silicone. Put another Thin line on top of the Gasket and Reinstall. This Silicone is High Temp Silicone and will Seal Very Well. Make sure to put oil Back in the Motor! Please Rate my Response, I need all the Help That I can Get! Thanks!

SOURCE: 2005 gmc yukon xl denali service ride control

it has to do with your air ride suspension best bet is take it to the dealer there is probably a problem with a level sensor. hope this helps you

Marvin

• 85242 Answers
• Posted on May 13, 2009

SOURCE: 2003 GMC Yukon XL Denali Service Ride control info

leaking suspension air bags is the most common cause, but the system can be tested for trouble codes, I suggest u do so, only the dealer can do this, but guessing about what the problem is can get very expensive very fast.

Mike Butler

• 6674 Answers
• Posted on Jul 12, 2009

SOURCE: GMC yukon xl liftgate is very heavy and has no

Can't recharge, but can get new at any big parts store chain like autozone, Pep boys etc. Not too expensive if I recall.

Greg Bernett

• 2993 Answers
• Posted on Oct 02, 2009

SOURCE: how to replace the blower motor fan assembly in a

Blower Motor Removal & Installation Delphi
Blower Motor Replacement (Delphi)


To Remove:

1. Remove the instrument panel sound insulator panel (if equipped).
2. Disconnect the electrical connector from the blower motor.
3. Remove the blower motor insulating cover screws.
4. Remove the blower motor insulating cover.
5. Pull the retaining tab down and rotate blower motor counterclockwise to remove.

1. Position the blower motor and turn assembly clockwise until tab locks in place.
2. Install the blower motor insulating cover.
3. Connect the electrical connector to the blower motor.
4. Install the instrument panel sound insulator panel (if equipped).

1. Remove the instrument panel sound insulator panel (if equipped).
2. Disconnect the electrical connector from the blower motor.
3. Remove the blower motor screws.
4. Remove the blower motor from the HVAC module.

1. Position the blower motor and install mounting screws.
2. Connect the electrical connector to the blower motor.
3. Install the instrument panel sound insulator panel (if equipped).