SOURCE: program a keyless enrty remote start 2004 chevy malibu
Dealer only If you find a different means let me know
SOURCE: 2004 chevy malibu classic spark plug replacement
Search for the engine model ECOTec 2.2 rather then Malibu. It is very easy to replace the plugs, they are DEEP inside the engine so you will need a 6" socket extension for the spark plug socket. Needle nose pliers were required to retrieve the socket on the first plug. Don't push down hard on the plug, just enough to engage the nut. Full screen photo sequence is available at:
http://www.gaownersclub.com/forum/showthread.php?t=99068
SOURCE: 2004 Chevy Malibu Classic and problem is turn signal goes out
the hazzard switch is together with the turn signals, so if they are not working properly, check hazzard switch. the switch has a built in timer for hazzards and turn signals.
SOURCE: replacing spark plugs on a 2004 chevy malibu
2.2L Engine
Allow the engine to cool before removing the spark plugs.
Attempting to remove spark plugs from a hot engine can cause the spark
plugs to seize. This can damage the cylinder head threads.
Clean the spark plug recess area before removing the spark plug.
Failure to do so can result in engine damage due to dirt or foreign
material entering the cylinder head, or in contamination of the
cylinder head threads. Contaminated threads may prevent proper seating
of the new spark plug.
Use only the spark plugs specified for use in the vehicle. Do not
install spark plugs that are either hotter or colder than those
specified for the vehicle. Installing spark plugs of another type can
severely damage the engine.
To install:
WARNING
Do not coat spark plug threads with anti-seize compound. If
anti-seize compound is used and spark plugs are over-torqued, damage to
the cylinder head threads may result.
Testimonial: "Thanks for the help, it was easy to change out the plugs with your info."
SOURCE: How do I replace a headlight bulb for a 2004 chevy
Change headlights in 2004 Chevy Malibu Classic
Open the hood and pull up on the two black tabs on either side of the lamp assembly. Pull the lamp assembly forward gently and unclip the wiring harness. Twist the socket counter-clockwise and remove it. The bulb should be removed by wiggling it.
Install new bulb in its place and turn the socket back into place. Reconnect the wiring harness and return the lamp to its original position. Line up the holes in the lamp assembly to the round ends of the mounting pins, and press down on the two black tabs to hook the lamp assembly into place.
1,005 views
Usually answered in minutes!
×