SOURCE: belt diagram 2004 5.7 liter engine dodge ram 1500 1/2 ton 4x4
click on this link, and scroll down to 5.7L
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ba71e
SOURCE: Dodge Ram 1500 can it have a plow?
if you do it do it at the dealer that you got it from so it wont void the warranty. that way you keep it in place and they can also tell you the specifications as to what you need to do ,if anything to the front of the truck
SOURCE: 2004 dodge ram 1500 rear brake light out how to replace?
Open up the tail gate, you will see two torque screws on the inside beside the tail lights. take these out, this will free up the housing and you can change it from there.
SOURCE: passanger side mirror replacement on 04 dodge ram 1500?
very easy take the mirror inside cap off if you can not get to the 3 bolts then you will have to take trim panel off to take trim panel off look for plastic caps take them out and unscrew them then pop out the bottom of the door and pop the sides out then lift up and out should be loose enough for the bolts now/ 10mm bolts 3 Please rate my response thank you very much
SOURCE: remove front axle from differential on 2003 dodge ram
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
198 views
Usually answered in minutes!
×