I just replaced my head gasket on my 2002 alero v6 engine. I just got everything put back together and when I went to go start the car I noticed the gas peddle was push all the way to the floor. I tri

SOURCE: 2002 Alero with 4 cylinder engine

usually its the plastic housing, also could be injectors not firing properly.

here is a little thread that should help...
http://www.automotiveforums.com/vbulletin/t644772.html

SOURCE: 1999 olds alero leaking coolant

problem could be heads bolts . i put new bolts in put a little sealer on them . make sure your bolt holes is clean free from debris. put a lillte sealer on intake gasket on top and bottom where coolants travel. if all was done . drain engine oil in clean container .set it aside. take radiator cap off .you a coolant pressure rise kit .put a pan under oil pan with drain plug still off .pressure your radiator about 10 psi. make sure you have antifreeze in radiator and engine . when you pressure up to 10 psi look under the car if coolant comes out oil pan. you got leaking head gasket. if not .put oil pan plug back on . put oil back in car . check your freeze plugs also.

Dar

• 2007 Answers
• Posted on Jun 17, 2009

SOURCE: 2002 olds alero wont start not security problem

You will have to see if you have spark and gas first of all. When you first turn the key to "on", you should be able to hear the fuel pump cut in for just a couple of seconds. If it doesn't, check fuses and relays. If they are okay check to see if there is power at the fuel pump. If there is, you need to change the fuel pump.
Get a timing light and hook it to any spark plug wire, and see if you have spark. If you don't, first, i would check the timing belt. If it's okay, try changing the ignition coil pack.
Let me know how you make out when you get that far.

SOURCE: Car idles rough, stalls - 1982 Oldsmobile Cutlass Supreme

check for black smoke at exhaust. stuck choke.... clean with carb. cleaner. could need adjusted. possible stuck float. no quick fix. diry fuel filter. replace.

SOURCE: clutch pedal went to the floor but did not come

there is a plastic clip that connects the clutch pedal to the rod that goes to the master cylinder, chances are that it let go. Bad thing is that it is only available from GM along with the rod. It is around 50