My 95 oldsmobile turn signals will not work at all. i have checked the flasher and all the fuses associated with the turn signals but have not seen any results.

One flasher only. Check fuses first. Then suspect the flasher as a possibility. I have seen the hazard switch cause the turn signals to malfunction. Try pressing the hazard button in. If they work and flash as hazards you know the bulbs and flasher are ok. If the turn signals then work you have a defective multifunction switch (the hazard/turn signal/etc switch)

It was not totally clear what you are trying to fix. Is it the turn signals or the hazard lights. Both can be referred to as "flashers".
The turn signals have an associated relay that may go bad...not necessarily the fuse.
A helpful to find the relay location is to turn on your signal lights and the relay will start clicking which will make it much easier to find

check flasher,fuse,bulbs shoted,and indicator lever...........

if the fuse is good and all the lights work(if you checked them when the hazards were working)then you need a signal flasher,the signals have a separate flasher and it looks like the hazard flasher.if you turn on the hazards and look for it under the dash then you know what the signal flasher looks like,it is located on the fuse panel of in that area.

There may be separate flashers for the Emergency 4 ways vs. the turn signals left or right. Try to replace the flasher for the turn signals located under the dash on the driver's side. That's the way my 1990 Cadillac was, and it may be the case for you.

most likely its your muti-funtion switch in the steering column.but first check your turn signal flasher & your emergency flasher

Your Olds has 2 flasher relays. One for the turn signals and one for the hazard lights.
The turn signal flasher relay is located on the driver's side, under the dash, mounted on the steering column.
The hazard flasher relay is located driver's side, under dash, driver's side of steering column, mounted on fuse panel.

the fuses for this car should either be under the drivers side dashboard or on the side of the drivers side dash.open the drivers door and there should be a removable panel on the side which says fuses on it.if the fuses are good,then the problem is your turn signal flasher which should be located in the same area where your fuse are.most of these flashers are round and are aluminum in color and that is where the clicking sound that you hear when the turn signal is engaged comes from.so if your fuses are all in good condition,check the flasher. hope this info helps you. take care and good luck, manny

You changed the hazard flasher or the turn signal flasher? It has two, one for the hazard and one for the turn signals

Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.