SOURCE: overdrive transmission
O/D light flashing is computer indicating an issue with the transmission -no surprise. Make sure the transmission fluid is still good (dosn't smell burnt, right level). Slipping could be the TCC (torque Converter clutch) - not a cheap part - but would only really slip in 4th gear (above 40 mph). Slipping before that could be numerous things in the trans (low fluid pressure, torque converter issues).
I would be tempted to replace the fluid anyhow, but there is a chance an expensive issue is starting to arise - and replacing the fluid on a failing transmission could cause it to fail 100% (or can fix it nearly 100%). These can be touchy transmissions, too much DIY without the right diagnostic tools can be bad. Not what you wanted to hear, and not an expert, but have had some expertise with these.hope that helps.
SOURCE: took off this morning and the escape started
you are right, its probably the fuel filter. wow 113120 miles without changing the fuel filter. also, change the air filter and have your intake manifold cleaned. this will greatly improve acceleration and fuel economy. best wishes - hotratchet
SOURCE: Troubleshooting my blender value in my Dodge Ram
sounds like u guessed right blender door is getting stuck motor is weak or mount is cracked
SOURCE: 2004 Mazda RX8 Heater problem
There is a well known problem that is a manufacturer's defect with the soldered connection on the circuit board behind the temperature knob. There is a fix to re-solder the connections but the dealer will gladly take $450 to replace it with the same bad board that will last you a while. Look for the link to show you how to fix it yourself.
SOURCE: oil light stays on, clicking noise when i push the gas!
is it low on oil? if so it could be an internal oil leak (wouldn't be able to see) or external but you didn't say anything about that... if level is good replave the oil pressure sensor
221 views
Usually answered in minutes!
×