S-10 stalls when put in gear

I would start by checking the fuel pressure.
https://jeep-manual.ru/index.php?page=320

engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Check that your not in 2 gears at once , put in to neutral by moving gear shift rods at the gearbox.

vacuum leak some where or a bad sensor in drive line some where

Could be alot of things. For starters i would look at the tcc solenoid. It should be located on the side of your tranny. If you unplug this and it goes into gear and runs fine then you found your problem. If this solenoid goes bad it prevents your tranny from downshifting and staying in a higher gear.

There is a safety switch on the brake pedal. You have to step on the brake to put it in gear.

The transmission solenoids are not working properly. Probably requires a transmission rebuild.
I don't think it's in the ground strap or wiring.
It's an internal problem with the transmission.

first try so SPT gas teatment may sure you have a half tank of gas and then put in a little more of gas if this help change the fuel filter also check the vaccum lines and make sure they are all on and in and good conditon and also checkout the intake manifold for leaks

its a common issue that once the low forward band in ford transmissions wear out that it will engage first and 2nd at the same time. of course this is not mechanically possible and the car stalls out.

your fix is to replace the transmission

if it is standerd then it is most likely your lutch try to keep your r.p.ms at the owest point you can before shifting if it is automatic it could be the pressure plate but im not an expert with automatics{yet again the change them so often that nobody really is}