TCS ABS lights on & alternator not fully charging

This is a Braking problem so you need to get it fixed soon. There is a problem somewhere in the Antilock Braking System (ABS) or the Traction Control System (TCS). You're best option is to get the vehicle plugged into a diagnostic system or an OBD2 scanner to find the trouble codes for this. Most places charge a fee for this so shop around as dealers charge a lot more than smaller garages. These codes will give you a more accurate idea as to where the problem is.

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

the traction control uses a mechanism that if it senses that your tires are spinning it will automatically set your ABS to reduce the spin and give you more traction. you should have had the TCS off before you raised it up bbut i think you should look in your manual for a way to reset it if not you may have to take it to the dealership and have them reset it for you. hopefully you didn't damage the traction control sensor

if your peddle is pulsing change the rotors they got to hot and warped do not get dealer rotors buy one after market with holes in them they cool better

Probably bad wheel bearing

you may have damaged the ABS sensor or wire to the sensor up front check the wire that runs from the inner finder well and make sure it connected to the ABS sensor on the spindle

Wheel speed sensor out of adjustment

dear friend-it sounds like one of the sensors(wheel)is faulty or one pne of the turnwheels came loose.

YOU MAY NEED TO TAKE IT TO THE DEALER FOR AREPROGRAMING OF THE ABS SYSTEM

haynes has one id try bleeding the brakes or replace them an bleed