Question about 2004 Mitsubishi Outlander

Open Question

How much coolant should I put in my Mitsubishi outlander

Excuse my ignorance but what goes in the tank that says coolant , is it water plus coolant or just coolant .

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 209 Answers

SOURCE: Need to know where the coolant temperature sensor is

do you mean thermostat if it is what you mean it is always under the radiator.

Posted on Apr 18, 2009

Ad
mcgyver468

Mark L. Roberts Jr.

  • 710 Answers

SOURCE: 2004 mitsubishi outlander cooling fans not operating

TAKE A PEEK UNDER THE HOOD IN THE FUSE PANEL FOR THE FUSE AND RELAY FOR THE COOLING FAN. IF THE FUSE IS BLOWN THEN REPLACE IT. IF YOU SUSPECT THE RELAY TO BE BAD THEN TEST IT BY SWAPPING THE FAN RELAY WITH ANOTHER ONE WITH THE SAME PINS ON THE BOTTOM. MAKE SURE IT IS THE SAME SIZE AS WELL. HOPE THIS HELPS.. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

Posted on May 16, 2009

Superbovine

  • 333 Answers

SOURCE: mitsubishi outlander cooling fans not operating

There is a Recall to replace your cooling fan module because of this concern.

Open your hood and look at the black box bolted to your radiator fan by the battery. If it does not have a green dot on it, you have not had the replacement fan module installed.

Contact your local dealer with your VIN handy to verify the recall has not been done and to schedule an appointment.

If the recall has been done, verify if you have power coming out of the module to the fans, as the fans do burn out eventually.... but rarely both at once.

Posted on Sep 10, 2009

Jerry Van Sickle

  • 334 Answers

SOURCE: i have just replaced the

Hello aislin87,

The total engine coolant capacity is 7.4 quarts.

Just changing the thermostat should not drain the entire system so you wont need that much.

The recommendation is above 30% but below 60% anti freeze to water to provide for proper freeze and anti-corrosion protection.

Regards,
netvan

Posted on Feb 27, 2011

kel1guy2002

Kelly

  • 3740 Answers

SOURCE: where is the water pump located on a mitsubishi

The here link in the original solution, (URL listed below) no longer works
http://www.out-club.ru/Manual/WSM/14_pdf.rar

Posted on Apr 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Mitsubishi, Outlander XLS....when I start in the morning in cold weather, I am not getting hot air during standby and when I start moving, I am getting hot air after few minutes drive. Then when I...


Check your coolant level when engine cold, low level coolant does not circulate very well at idle and will cause poor heating,at higher RPM water pump turns faster to help circulate.
press the helpful button,

Jan 29, 2016 | 2007 Mitsubishi Outlander XLS

1 Answer

When you change timing belt


I diid on my 2004 last year car had 85000 kms.Do it before 100000kms.Wasn't expensive I think 200-300 plus coolant change. .Stay away from dealership and save hundreds, find honest good mechanic.

Jan 07, 2013 | 2004 Mitsubishi Outlander

1 Answer

How to use gearshift on 2003 outlander


Yes. The plus and minus allws you to manually pull the transmission out of overdrive. Contact a Mitsubishi Service dept for specific details pertaining to its function(s).

Apr 22, 2012 | 2003 Mitsubishi Outlander

1 Answer

I have just replaced the thermostat in my mitsubishi outlander 2006 zf 2.4l auto wagon and I am flushing the radiator but i need to know the coolant/radiator capacity and the ratio of coolant/water


Hello aislin87,

The total engine coolant capacity is 7.4 quarts.

Just changing the thermostat should not drain the entire system so you wont need that much.

The recommendation is above 30% but below 60% anti freeze to water to provide for proper freeze and anti-corrosion protection.

Regards,
netvan

Feb 27, 2011 | 2006 Mitsubishi Outlander

1 Answer

Car alarm doesn't make any sound when activated or deactivated


WHY BOTHER!!!!!, what use are car alarms anyway,...everyone ignores them or yells at you to turn it off because it is waking up the baby at night....it has a fabulous immobiliser anyway, plus you can't start it without the key as the ignition key has a microchip that talks to the car's computer...If all else fails, and you are worried about the contents of your vehicle,...put an angry rattlesnake in your car....

Dec 24, 2010 | 2005 Mitsubishi Outlander

2 Answers

How do i change out my thermostat?


Mitsubishi Outlander 2003-06

Removal & Installation
  1. Disconnect the negative battery cable, then the positive battery cable.
    CAUTION Wait at least 90 seconds after the negative battery cable is disconnected to prevent possible deployment of the air bag.
  2. Drain the engine coolant.
  3. Remove the air cleaner assembly.

    0ce2f62.jpg
    Fig. Exploded view of the air cleaner assembly
  4. Remove the battery and battery tray.
  5. Matchmark the installed positions of the hose and hose clamp, then disconnect the lower radiator hose from the water inlet fitting.
  6. Detach the control hose electrical connection.
  7. Remove the control wiring harness connection bracket.
  8. Unfasten the retainer(s), then remove the water inlet fitting.
  9. Remove the thermostat.

    fd7b157.jpg
    Fig. Exploded view of the thermostat mounting

To install:
  1. Installation is the reverse of the removal procedure, noting the following:

    Install the thermostat so the jiggle valve is facing straight up. Be careful not to fold or otherwise damage the rubber ring.

    56e4421.jpg
    Fig. The thermostat-s jiggle valve must be facing up, at the 12 o-clock position during installation
    Refer to the fastener tightening specifications shown on the accompanying illustration. During installation of the lower radiator hose connection, insert the hose as far as the projection of the water inlet fitting. Align the matchmarks on the hose and hose clamp, then connect the hose.

    92546ba.jpg
    Fig. Insert each hose as far as the projection of the water inlet fitting. Make sure to align the matchmarks before connecting the hoses
    Fill the engine with the proper type and amount of engine coolant.
  2. Connect the positive, then the negative battery cables, then start the engine and check for leaks.

Hopw helps with this (remember rated this).

Jul 11, 2010 | 2003 Mitsubishi Outlander

1 Answer

Fule filter mitsubishi outlander


the outlander does not have an external fuel pump the only one is in the fuel tank on the end of the fuel pump and it shouldnt need changed unless you have alot of trash in your tank inwich you will have to remove your tank to clean it out anyways

Jun 04, 2009 | 2004 Mitsubishi Outlander

1 Answer

Need to know where the coolant temperature sensor is


do you mean thermostat if it is what you mean it is always under the radiator.

Mar 21, 2009 | 2004 Mitsubishi Outlander

Not finding what you are looking for?
2004 Mitsubishi Outlander Logo

Related Topics:

676 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...