Can I place the right front abs sensor on the left rear?
SOURCE: brake lights for nissan pulsar 1998,abs lights for same
check the fuses for the rear tail lights, check the lights, make sure they are not burnt out. (abs cable is probably not the problem, but have it changed so you know that there isn't one)
SOURCE: Speedometer/odometer/cruise control isn't working.
It's your speed sensor at the transfercase on the drivers side i believe. Check the wire and clip to the sensor for any break or loose contacts.
Easy fix and is about a 30 min job to do with simple tools.
Un-clip the wire conntection, remove the retainer bolt and slide and sensor out. To install just do everything in reverse and add transmisson oil if needed.
Most of the time, it's going to be the sensor. Keep in mind that there are two sensor's so make sure it's the one on the output shaft at the transfercase. The other one is closer to the front of the transmission on the same side with is the input Volosity speed sensor.
If it was your ABS sensor, you ABS light would come on in your dash.
Good luck and hope this helps
SOURCE: Directions replace front wheel bearings on a 1985 nissan stanza?
NOTE: After the wheel bearings have been removed or replaced or the front axle has been reassembled be sure to adjust wheel bearing preload. Refer to the Adjustment service procedure below. On the 1989–92 240SX there is just one wheel bearing, pressed into the hub and no adjusting cap. Refer to the exploded views of the Front Axle Hub Assembly. Review the complete service procedure.
SOURCE: Camshaft sensor - where is it?
There are two cam sensors and they are located on the back of each head in line with the intake cams.
DTC No. 32 is for the left front speed sensor.
DTC No. 33 is for the right rear speed sensor
DTC No. 34 is for the left rear speed sensor.
604 views
Usually answered in minutes!
×