Can not turn on or off,tried to check speed sensors, connections.reading was4.5 /11.23to11.53 why was i not able to retrieve codes was able to start but got as far as 1.9 but would not proceed any furter. what can i do? also is it possible that changing battery could have caused this?
You will get your solution and all info on service info, repair info, parts info, wiring/electrical/fuse diagrams, error/fault codes, torque specs, PCV,
owner's/service/repair/parts/maintenance manuals etc everything
this website www.reliable-store.com
it's a very good website for vehicle problems even as old as 1991 ford..
SOURCE: 2004 toyota rav4 does not accelerate
check fuel injector rail pressure sensor take plug off one side iff engine does not cut out change sensor
SOURCE: 2004 Sequoia. VSC TRAC, TRAC OFF, and Check
It is not hard to change the sensor, it just screws into a threaded hole. The light will not go out immeditaly, after the sensor is replaced. It needs to go thru a drive cycle. Your best bet is to replace the sensor and get the code cleard by whoever scanned it for the 0031 code.
SOURCE: 2005 Toyota Camry - knock sensor
Your sensor went off because it overknocked.
Try using a different type of fuel with a higher octane.
Erase the code and use the better gas. if it comes back then we will worry about replacing it.
SOURCE: VW BEETLE , ASR
First of all replace bad wheel bearing !!! This bad wheel bearing causes ASR light ON.
ASR - Acceleration Skid Control system.
When ASR warning light blinking the system is activated itself for car acceleration skid control.
For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety, particularly when driving on slippery roads or surfaces offering differing levels of grip. Traction control permits smooth starting and acceleration through the full speed range without wheel-spin or fishtailing.
ASR only operates in conjunction with the electronic accelerator (E-gas) and uses components of the anti-lock braking system (ABS). If one wheel suddenly begins to rotate faster than the others (slip), ASR intervenes in the engine management system and reduces power until the wheel stops spinning.
The ASR system represents a further contribution to active safety as it maintains vehicle traction and directional stability throughout the acceleration phase at any speed. In addition, it reduces tyre wear. Activation of the ASR system is indicated by a flashing indicator lamp in the instrument cluster.
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
99 views
Usually answered in minutes!
×