SOURCE: toyota 2e engine
Hi,
The only positive way to check if the oil pump is working and therefore there is correct oil pressure is to temporary install a non-electrical oil pressure gauge that uses a small copper tubing to sample the oil/pressure and drive a needle on the gauge. Depending on temperature, idle should register about 20+psi. Having done this and confirmed that indeed there is sufficient oil pressure then it may simply be a defective oil sending unit. Otherwise, no or low oil pressure at idle is an indicator that the engine needs to be opened up again.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
SOURCE: 1986 toyota corolla 2E engine high fuel consumption
why does my normal rpm always bug down when the engine start?and when I started to use the air con, the rpm was playing. It doesnt go on a certain point. it always range at 800rpm then it will down to 700. what am I might do to solve this probem?
SOURCE: whats the torque setting for big end bearing bolt
hi big end bearings are two stage, 25nm leave ten mins, then 49nm cylinder head bolts three stages 20nm leave ten mins, 40nm leave ten mins then 60nm check after 5,000miles hope this helps
SOURCE: Does a Toyota 2E engine (Corolla) has a Thermostat
it DOES have a thermostat,and a thermo switch.....
SOURCE: i need a vacumm diagram
Toyota has been building cars and trucks for 50 years and they have manydifferent engines and are made for sale in almost every country in the world. 2E engines haven't been made for sale in the USA so aldata won't help you. Your dealers Parts department may copy off the icture of these lines from the parts manuel so yu mightbe able to see where they go Usa models are required to have the vacume picture affexed to the inside of the hood or firewall as a conition of sale in the USA. Laws like this vary from country to country. The cars in the USA have fuel injection after 1988 and so their are very few vacume lines so the pictures are no longer needed after then.
195 views
Usually answered in minutes!
×