SOURCE: Lower Control Arm Bushing replacement
Hi,
I just did this job on my 98 regal, and I own the service manuals also. The lower control arm bushing that usually goes, is the front one. The rear one doesn't usually go, it is horizontally mounted. The front one for some reason is vertical. The control arm must be removed, and put in a vise. The front bushings outer metal sleeve, must be driven out with a chisel. It comes out easily. The new bushing can be tapped in with a hammer. Hope this helps!
JOEVETTE
SOURCE: tire size for mitsubishi outlander
Here's a good tire calculator and it gives you the speedo changes etc.
Tire calculator
SOURCE: Can I install bigger tires on Mitsubishi Outlander?
the 225 is the sidewall size, the height of the side wall. I also have the same vehicle with a low-profile tire, I know there is not a lot of room in there to go much taller if any. I do see where there could be a problem with the computer but it's a computer it should be able to be re calibrated.
SOURCE: mitsubishi outlander cooling fans not operating
There is a Recall to replace your cooling fan module because of this concern.
Open your hood and look at the black box bolted to your radiator fan by the battery. If it does not have a green dot on it, you have not had the replacement fan module installed.
Contact your local dealer with your VIN handy to verify the recall has not been done and to schedule an appointment.
If the recall has been done, verify if you have power coming out of the module to the fans, as the fans do burn out eventually.... but rarely both at once.
SOURCE: remove rear brake drum 2004 Mitsubishi Outlander
Dear Brake Drum Remover,
I'm gonna tell you how to pull this drum off, ya ready?First off, get the rear of the vehicle up in the air safely, Then pull the rear tires off.After those are off then take a gander at the face of the drums, are there shiny brass looking screws installed on the face of that drum?Ifso remove those counterclockwise, then, take a hammer a shock the face off the drum firmly about three times.Now, go to the opposite side on the face of the drum and do that again, keep on doin that until you can wiggle the drum off by hand...easy as that, any other questions get back to me. I'M HERE TO HELP!!!
37 views
Usually answered in minutes!
×