I need diagrams or pictures on how to remove water pump on a 1994 Lebanon chrysler
SOURCE: Power steering pump pulley removal
Go to your local auto parts retailer and buy or rent a power steering pulley puller. They usually run about $39 to do either, but since you probably will not use it much, why add another dusty tool to your box? If you rent it, the $39 is usually just a fully refundable security deposit, so you basically get to use it for free. Most of the pullers usually consist of a two section fixture that slips over the hub of the pulley, then a nut and a long shaft bolt are threaded through, and a sleeve goes over the assembly. You then turn the nut to back off the pulley. The kit should also include the installation tool, which consists of a bolt that you thread into the shaft of the pump and a nut and washer that you turn to slowly press the pulley on to the shaft. It is easier to do this job with the pump out of the car, with the pump clamped on your bench, but can be done with the pump on the car. Just be prepared to lose some skin and blood if you are not wearing gloves. The pulley is made of phenolic resin, formerly known as bakelite, and will break or chip easily, so be careful. Although the temptation will be strong to whack it with a hammer, don't give in. You can easily damage the new pulley and the pump itself.
SOURCE: I need to replace water pump on 1995 Chrysler Le Baron
This will take some digging. You would be money ahead to go to a parts store and buy a haynes or chilton manual for 20 dollars. The waterpump is ran by the timing belt, so you will want to replace that to. You also need to know how to line the timing marks up to get the belt back on right. The manual will give you all the info you need.
SOURCE: Need to change fuel pump on 1994 chrysler lebaron 3.0 v-6
yes u need to drop the tank out. there is no underseat access.
SOURCE: i NEED A DIAGRAM SHOWING HOW TO REMOVE THE TIMING
it be in your best interest if you would buy a Haynes book on your car from AutoZone for about $20.00,
It is what I use at the shop,it gives alot of info even wiring diagrams,to engine rebuilding.
SOURCE: how do i replace the water pump on a 1997
First, keep a copy of this serpentine belt diagram to help you put it back on when you're done replacing the water pump...
Here's a link to a video by Advance Auto Parts on how to replace the water pump...
http://www.wonderhowto.com/how-to/video/how-to-replace-a-water-pump-in-a-vehicle-102464/
114 views
Usually answered in minutes!
×