Need torque procedure on rocker arm bolts and also on the intake manifold and what pattern to tighten them in 3.4 6 cylinder
I could not answer this any better than what I have found online. Here is a guy that has posted removal and re-installation in great detail as well as great photos.
LIM and Head Gasket Change Walkthrough FAQ GrandAmGT com Forum
I give all the credit for this answer to the poster.
I could not answer this any better than what I have found online. Here is a guy that has posted removal and re-installation in great detail as well as great photos.
LIM and Head Gasket Change Walkthrough FAQ GrandAmGT com Forum
I give all the credit for this answer to the poster.
×
SOURCE: I am changing intake gaskets
89 inch pounds then 30 degrees. make sure the push rods get put back in same place they came out they are different lengths. If you ever do another one of these buy the tool for the rocker arms and you will not have to remove them or the rear valve cover. please rate
SOURCE: need head bolt,intake upper and lower and rocker arm torque lbs.
Head bolts--------- 22 ft lbs.
Intake upper------ 18 ft lbs.
Intake lower------- 10 ft lbs. Tighten vertical bolts first, the diagonal bolts, failure to do this will result in an oil leak.
As far as the rocker arm bolts, they have to be adjusted with the valves closed, tighten down just enough to turn the push rods with your fingers with slight tension.
This is out of a Technical Specifications Manual.
1,208 views
Usually answered in minutes!
×