How do I install new rear wheel bearings on my 2008 ford edge
SOURCE: what torque for rear wheel bearing Ford Focus 2000
Can only find out that the hub needs to be tightened to
235 nm Dunno if this helps
SOURCE: 1996 ford windstar - changing rear wheel bearing passenger side
No on this model they are held in by a nut and cotter pin. You can remove them by hand.
SOURCE: rear wheel bearing
SECTION 205-02B: Rear Drive Axle/Differential — Ford 8.8-Inch Ring Gear
2003 Mustang Workshop Manual
IN-VEHICLE REPAIR
Axle Shaft
Removal
Remove the U-washer (4N237).
Carefully remove the rear brake anti-lock sensor. For additional information, refer to Section 206-09A .
--------------------------------------------------------------------------------------
Remove the axle shaft.
Rear Wheel Bearing and Axle Shaft Oil Seal
Removal
Installation
Using the special tools, remove the rear wheel bearing and wheel bearing oil seal.
-------------------------------------------------------------------
Installation
Install the two axle shafts.
Install the U-washer.
Install the differential pinion shaft.
SOURCE: Rear Wheel bearing needs to be replaced
the bearing has to be pressed in, quite the job even doing it at the shop- you will have to have some sort of press to press the bearing in.
SOURCE: replace rear wheel bearing 2002 ford explorer 4x4
you must remove brakes, then remove axle nut, then remove upper control arm and finally tie rod stabilizer, remove axle from car then bearing can be accessed. this is a difficult job that requires special tools so be careful
1,260 views
Usually answered in minutes!
×