It needs 3500 to 4000 RPMS before it shifts from first to second. After that it works fine.
SOURCE: 1994 FORD RANGER STANDARD TRANS CLUTCH WON'T ENGAGE
The only adjustment you'll probably need is to get the air out of the clutch line. Loosen the bleeder screw, and put a two or three foot vacuum line on it. Submerse the other end of the line in a bottle of brake fluid. Pump the clutch untill no more bubbles are coming out of the hose into the bottle. Be sure to keep the reservoir topped up while you do this. Hold the clutch down, and tighten the bleeder screw. Some hydraulic clutches do have an adjustment on the rod that goes from the slave cyllinder to the pressure plate. I'm not sure about yours. If there is a nut on the rod, you can adjust it somewhat. You want it set so that there is just a little bit of play between the rod and the pressure plate where the rod goes. If none of this helps, you mayneed to replace the slave cyllinder.
SOURCE: How do you remove the gear shift lever on a 93 ford ranger?
many of these trucks have a mazda trans in them, to remove these shifters you will need to remove the 4 phillips head screws from the corners of the trim around the shifter boot and pull it up out of your way. it's not necessary to remove the boot from the shifter, just lift it up for access to the top of the trans. at the base of the shifter on the top of the trans you will see a plate attached with torx head screws. remove all but 2 of them, now make sure the trans is in neutral and remove the last 2 screws and pull the shifter straight up. the shifter is now out leaving a big hole open on the top of the trans for dirt to fal into so put a wrag in it or screw a piece of cardboard to it. installation is the reverse. good luck
SOURCE: Having problems with the clutch in my 1998 Ford
The clutch is not adjustable,it is a fluid clutch.It has to be a leak,or the slave cylinder,and,or, the master cylinder are bad,It does not have to be leaking to be bad,but it is one of the two.Rate please,thank you.
Testimonial: "Wow. I was not expecting an answer back. Not only was it helpful, but it was also quick. Thank you so much."
SOURCE: transmission shifts late 89 jeep cherokee 4.0l Auto
i have 1989 jeep cherokee auto wjen put in drive it starts out in 4th gear and goes slow until it builds up speed
59 views
Usually answered in minutes!
×