My Daewoo lanos is showing fault code 4040 and ABS light is on. can anyone help me find what this fault code means please
SOURCE: 2002 Daewoo Lanos Engine Type
Yes, this is an interference engine. I just finished fixing mine and it is a big expensive job. Sorry to give bad news.
SOURCE: !999 Daewoo Lanos
It verifies well the year, it is of one of 1999
I hope that it should serve you
SOURCE: 2001 Daewoo Lanos Fault 63.58X 'B'
DTC 63 Will Set When
No voltage is supplied by the ECM through the EST “B” line while reference pulses are received by the ECM from the crankshaft position sensor
check white wire terminal B on ignition coil to ECM terminal C14 for open circuit or short to ground while disconnected if thats ok check for voltage signal at B while cranking no signal ECU faulty. voltage signal also on A terminal while cranking and check earth terminal C to body no higher than 5 Ohms
power is terminal D 12V
if getting power, earths good, and both signal voltages are going into coil pack, coil pack is faulty.
SOURCE: What does a P0342 code mean?
hallo
P0342 code means: camshaft position sensor- low imput. Check wiring (short to earth), if OK change camshaft position sensor.
Marko
SOURCE: How Do i manualy reset Fault codes on a daewoo
as most of the "experts" here I only saw standard awnsers.
reset Daewoo ECU:
1. Disconnect - (minus) battery connector for at least 30 secs.
2. reconnect it.
3. turn the ignition key on and of 3 times for 5 seconds (critical!)
4. start engine after 3rd time.
ECU reset is complete.
323 views
Usually answered in minutes!
×